JAPAN AIRLINESBOEING 767-300ERAssembly method

You need prepare adhesive and nippers for assembly. You need prepare water and dry towel for stick seal. If you want to paint, you need paints.

Step 1 Engine Assembly

D9

D10

D12

D13

D9

D15

D14D11

Left EngineRight Engine

You cut D9~D15 parts. D9, D10, D12 and D13 is right engine parts. D9, D11, D14 and D15 is left engine parts. You assemble those parts with the use of adhesive.

Step 2 Fuselage Assembly

C5

B1

BALLAST PARTS

A1

A weight is put on the front to put gravity at the front. A weight is that C5 is insert screw BALLAST PARTS.This step is big parts of all step. But, The place where glue is put is small.

Step 3 Main Gear Installation

This Step is made very small parts. D3(D4) will be put on other parts. C7(C6) is D3(D4)’s outside and D5(D6) is D3(D4)’s inside. When glue isn't put tightly, it comes off. So, It is need to put glue tightly.

D5D7

C7

D7

D3 D4

C6

D6

Step 4 Nose Gear Installation

First, you will cut C8 and D8. Because a part is small, please be careful.Next, attach 2 of D8(tire) to C8.

D8

C8

Step 5 How to make shuttlecockFirst, you cuts parts C1, C2, D1 and D2.

And then C1 and D2 join, C2 and D1 join. Second, you cuts parts C3 and C4.

D2

C2C1

C3 C4D1

Fourth, paste a pasteboard to plane with wet fingersFinally, take off a pasteboard leaves a sticker on the plane

Step 6 How to put stickersFirst, cut each a sticker with pasteboard which you want to use.Second, float a pasteboard on the water for about 20 secondThird, place a pasteboard on a tissue paper to dry

Step 7 CombinationPlease Make them combine parts of the former step and C3,C4(Horizonal Stabilizer Installation) with the Fuselage.

Engine Main Gear

C3

C4

Wing

Nose Gear