isometric drawing part 1. isometric projection isometric projection is a 3ddrawing using the 30-60...
TRANSCRIPT
Isometric Drawing Part 1
Isometric Projection
Isometric projection is a 3Ddrawing using the 30-60 degree angle set square.
All Isometric drawings start with three basic lines forming the corner of a “box” that contains the object you are drawing.
It is very important that the 30-60 degree set square is placed on the parallel motion/sliding ruler when drawing your angled lines.
At all times the drawing equipment is there to assist in drawing shapes and objects without too much measuring or calculating.
Use A3 Paper1cm border, 1cm name bar, 2cm indent.
200 mm
First three lines….
Use 30-60 degree setsquare to get eachangled line correct
Sliding ruler
Sliding ruler
195mm (19.5cm)
80mm
120mm
Remember to use a 30 degree Angle set square placed on the sliding ruler for all the angled lines
80mm
40mm
Use 30 degree angles to join up the roof
80mm
Measure 10mm gaps along the ridge on the roof
10mm
Use 30 degree setsquare
Mark off 5mm spaces on the base sides of the roof
Place your set square at the 60 DEGREE angle to draw in the tiles
Repeat on the right side of the roof