ipad wall mount plus poe power - heckler design 10.2 inch... · 2019-10-18 · 3 install ipad 4...
TRANSCRIPT
Assembly & Installation
H608
Limited Warranty
Heckler Design warrants your product to be free from defect in material and workmanship for a period of two years from the original date of purchase. Electronic components are warranted to be free from defect for a period of one year from the original date of purchase. If you discover a defect, please contact [email protected]. Heckler Design will repair, at our discretion, using new or refurbished components. If repair is not possible, Heckler Design will replace the item.
Compatible with:
iPad 10.2-inch 7th Generation
Heckler AV®
iPad Wall Mountplus PoE PowerSecure Wall Enclosure for iPad 10.2-inch 7th Generation
1x
Torx assembly toolF756
1:1
1x
Hex assembly toolF529
4x
4x
Drywall Mounting Screws
Drywall Mounting Mollies
F360
F155
Drill Marker Wire cutter
1 Remove front bezel
2 Disassemble screws
3
F529
3 Install iPad
4 Mark four mounting position and
4
CAT cable position
Mark the circle concentric to the cutout
F529
Please place iPad aligned to the slot
5 Install Drywall Mounting Mollies
5
6 Drill CAT cable pass-through hole
Please drill a 1/2 inch hole for CATcable to pass through
F155
7 Pull out CAT cable
6
8 Fasten back plate
F360
9 Cut out cable skin
7
10 Plug four wires into the 24V passive PoE splitter
Please match the wire color indicator on the plastic case.
Please only use the 24V PoE injector
1. Open caps 2. Insert wires
3. Close caps 4. Done
8
11 Plug in right-angle lightning cable
12 Install front bezel
9
13 Tighten four screws
Tip: Access Sleep/Wake button
F756
F756
Please tighten all four screws locatedon the third slot of each side