installation procedure2
DESCRIPTION
Installation Procedure2TRANSCRIPT
BEFORE INSTALL THE NEW BULKHEAD ( REMOVE THE EXISTING LONG. BULKHEAD 13.3M off C.L )WITHOUT CUT MAINDECK FOR ACCESS )
Condition : Full Ballast, Empty Oil. ( IN FLOAT CONDITION )
Result : Acceptable under Allowable Stress 355 x 0.8 = 284 MPA ( 279 MPA )INSTALL HALF THE NEW BULKHEAD FOR REINFORCEMENT ( REMOVE THE EXISTING LONG. BULKHEAD 13.3M off C.L ) WITHOUT CUT MAINDECK FOR ACCESS )
Condition : Full Ballast, Empty Oil. ( IN FLOAT CONDITION )
Result : Acceptable under Allowable Stress 355 x 0.8 = 284 MPA ( 239 MPA )