Part Number: DOD-201-04

072604-1

INSTALLATION INSTRUCTIONS

Dodge Durango(2004-2007)

Chrysler Aspen(2007)

NOTE: READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT.All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break.

Locate and remove the two (2) screws below the power outlets using a 9/32” socket and driver. Set the screws aside. Insert the Dash Trim tool in the lower right side of the bezel to release the lower right clip. Once this clip is released, continue working the bezel loose until all remaining clips are free. Note: There are three clips on each side of the trim bezel. Once all clips are released, tilt the bezel out and downward to release the lip at the top of the bezel.

Disconnect the three climate control, and two (2) power outlet plugs. Set the bezel aside. With a 9/32” socket and driver, locate and remove the four screws that hold the radio in place. Continue by removing the two screws that lie near the bottom of the radio mounting bracket. Set the screws aside. Pull the radio out, disconnect the wiring harness, and carefully set it aside. Note: Set radio on protective cloth to prevent damage.

Locate and remove the two (2) Phillips screws located in the back of the radio cavity. Set the screws aside. Locate the lower right screw hole that holds the radio mounting bracket in place. Pull the radio mounting bracket out just enough to slide the Custom Bezel Mount behind the tab. Align the hole in the mount with the screw hole. Insert the factory screw and tighten.

Carefully reinstall the dash in reverse order securing all wiring, clips, and screws making sure the bezel is secure.

Install any Bracketron phone holder or Amps compatible device to your Bezel Mount. Your installation is complete.

TOOLS NEEDED: Dash Trim Tool, (Part #SIT-104), #2 Phillips Screwdriver.PARTS INCLUDED: Custom Bezel Mount and Instructions.LOCATION OF MOUNT: To the right of the radio.

Step 1.

Step 2.

Step 3.

© Bracketron Inc, 2007 All rights reserved.The information in this document is subject to change without notice. Bracketron Inc. assumes no responsibility for any errors that may appear in this document nor do we assume any liability in connection with its use. This supersedes and voids all previous literature. Please contact the sales department for additional information.Bracketron Inc will not be responsible or liable for damage to vehicles in the installation and or removal of this Bracketron Inc mount.Bracketron Inc will not be liable for personal injuries or damage to property resulting from a motor vehicle accident and or improper installation of this Bracketron Inc mount.

Bracketron Inc 5249 West 73rd Street, Suite G, Edina, MN 55439, Ph: 952-746-7775 Fax: 1-800-660-1784 Toll Free: 1-866-237-4443Web Address: www.bracketron.com

Logo and part number will be right side up and readable when installed.

Use Existing Screw

Remove Eight (8) Screws

Alw

ays

chec

k ou

r web

site

for t

he m

ost u

pdat

ed m

odel

yea

r com

patib

ility

info

rmat

ion.