INSTALLATION INSTRUCTIONS

(Helix Wind Turbine)

Horizontal arms

-4/5/7pcs

blades-2pcs

axis rod-1pcs

outer side

inner side,

near the

axis rod

up side

down side

location hole

for the first arm

lock nuts for blades-M6 spring washer & flat washer for blades

screws for the arms-M8*20)

anaerobic fastening adhesive for arm screws.(Liquid material can not be shipped by air. please buy it in your local market)

INSTALLATION INSTRUCTIONS(Helix Wind Turbine)

Don't fix the last arm, keep it free

Note: fasten the 2 screws to fix the first (above) arm, the screw shall meet the location hole in the axis rod

Pay attention to the direction of the arms

INSTALLATION INSTRUCTIONS(Helix Wind Turbine)

1. fix the blades' inner side to the arms from upside to downside, but don't fix the last socket.2. bend the blade while turning round one arm(one by one from the upside) untill the arm meets the hole in the blade's outer side. then fix it with crew and washer.3. fix the blade to the last arm after all other blade sockets fixed. first fix the inner side then outer side. then fix all arms to the axis rod from upside to downside.

INSTALLATION INSTRUCTIONS(Helix Wind Turbine)

1. Fix the generator to the axis rod after all blades installed. rotate and inspect it, make sure everything is ok.2. One by one, remove the screw which fixes the arm to the axis rod, glue it with anaerobic fastening adhesive, then reinstall it. 3. Fix the generator flange to the pole(made by the buyer), connect the 3 output wires to your controller, then the stallation finishes.

INSTALLATION INSTRUCTIONS(Helix Wind Turbine)