installation instructions for k10472 kit ...camaro engine tensioner • a/c bracket for truck or 5th...
TRANSCRIPT
Camaro engine
Tensioner
•
A/C Bracket for truck or 5th gen Camaro LS engines
•Idler pulley
Installation Instructions for K10472
Additional parts required:
•
Kit contents:
less vibration.
Mounting plates•Spacer tubes•Fasteners
- Belt. See chart below.- AC compressor, Sanden "508" style. Typical SD5 Sandenpart number is 6629. However, we recommend the SD7Sanden part number 4665 for smoother operation and
www.kwikperf.com
IndicatorReferencemarks
Proper tensioner positionwith belt installed:
groove compressor.
Belt installationNote:Install belt in rear 6grooves of the 7Truck engine
16.30
15.22
12.07
13.86
6.7" diameterpower steering
pulley
6.0" diameterpower steering
pulley
5.5" diameterpower steering
pulley112.88" K061123 102.6" K061020 98.13" K060975 97.13" K060966 96.88" K060962 91.25" K060909
Factory GM 2010+Camaro Alt/PS
bracket and pulley
Kwik Performance Alt/PS bracket K10168Kwik Performance
alternator onlybracket K10195
Factory GM truckAlt/PS bracket and
pulley
Belt length and Gates PN - K10472 AC bracket - Truck (130+ amp alternator) and 2010+ Camaro spacing
12.00304.80
279.4011.00
M10x75mm bolt
tensioner &4. Install
idler pulley
M12x55 bolt
SpacerNote: Only install if thebelt runs off the rear ofthe tensioner pulleyafter installing the belt.
A
Bolt screws into water pump
M10x40mm on 2010+ CamaroM10x80mm on truck engine
1" OD tubes:2-1/4" long for truck engine23/32" long for 2010+ Camaro
2. Install WaterPump Bolt
50 ft-lbs (68 N-m).Tighten 12mm fasteners to
3. Installcompressor
1. Installbracket
All rights reserved
to 37 ft-lbs (50 N-m),
Copyright 2018-2019
5. Tighten bolts.
Kwik Performance, Inc.
Tighten 10mm fasteners
Installation Instructions for K10472A/C Bracket for LS engineswith truck or 2010+ Camaro balancer
Front plate
Do not torque until
screw into headuntil finger tight.
after step 4.TUBES
Rear plate M10x150mm bolts
1" OD x 1-9/16
1" OD x 3" TUBES
M10x55mm
M10x35mm
3/4OD x 3/4 LG tube
F