installation-guide for herzeg novi - tuhhdaad.wb.tu-harburg.de/fileadmin/backusersresources/... ·...
TRANSCRIPT
MS + BCE – Installation Guide [SR]
Installation-Guide for Herzeg Novi
This guide helps you to install following Software – Cluster:
This software cluster is provided to you for educational purpose throughout SummerSchool
2005. Since the license will not be granted to you permanently, you are obliged to de-install
the software at the end of the SummerSchool. You are responsible for the de-installation and
you have to convince Sebastian of this process.
Step 1/6: Install the GIS Environment
Install MicrostationSE from CD#1. Chose the setup.exe from following path of this CD:
.\BCE2D_MicrostationSE\MSSE\ENGLISH\WINDOWS\disk01
Follow the instructions and accept all suggested settings. Hence, you install the software to
following path:
c:\win32app
© S.Rath, ABWB, TUHH Page 1 of 4
MS + BCE – Installation Guide [SR]
Step 2/6: System Settings to use the Plug-in
To make use of the Plug-in, you must teach the GIS component that it exists and where it is
stored. Hence you must set two environment variable (german: Umgebungsvariablen). This is
done under
German : Start >> Einstellungen >> Systemsteuerung >> System
English : Start >> Settings >> System Control (?) >> System
In the Slider Extended you should find the environment variable (Umgebungsvariablen)
tag. Here you add two settings:
Environment Variable Value
MS c:\win32app\ustation
BCE_TEMPPFAD c:\bce_tmp
© S.Rath, ABWB, TUHH Page 2 of 4
MS + BCE – Installation Guide [SR]
Step 3/6: Set folder for temporary data for Plug-In
The Plug-in processes writes temporary information and needs a folder to store it. The folder
name was specified in step 2. Generate this folder: Named bce_tmp under C:\ .
Step 4/6: Rename installed GIS Folders
Some folders of your MicroStation Installation need to be renamed. Following tables lists
their paths and names. The renaming always adds the appendix ‘…_old’!
Before Renaming: Path + Name After…
c:\win32app\ustation\wsmod …\ wsmod_old
c:\win32app\ustation\mdlapps …\mdlapps_old
c:\win32app\ustation\licence …\licence_old
c:\win32app\ustation\wsui\default …\ default_old
© S.Rath, ABWB, TUHH Page 3 of 4
MS + BCE – Installation Guide [SR]
Step 5/6: Add the Plug-In to you GIS installation
Add the plug-in files from CD#1. You will find these files under
.\BCE2D_MicrostationSE\BCE_2D_install
Copy following components to their destinations:
Component Destination
wsmod c:\win32app\ustation\
mdlapps c:\win32app\ustation\
licence c:\win32app\ustation\
default (in folder: wsui) c:\win32app\ustation\wsui\
Finally, remove the write protection in folder c:\win32app for all its subfolders.
Step 6/6: Exercise Data Sets
Get CD#2. Provide a folder for your simulations on your hard drive, chose a short path, e.g.
C:\SummerSchool\
ata you find in the folder 2d_Modell_kelling_STUDENT on the CD. The your Copy the exercise d
folder should contain following data sets (approximately 59.5 MB).
© S.Rath, ABWB, TUHH Page 4 of 4