PN: 6127

Installation Guide

Installation Instructions for KM 1061 Uni Pro Seat & Suspension in

Case IH 9100 & Steiger Series Tractors (PN: 6906)

Phone: 1.800.328.1752 / Website: www.tractorseats.comTechnical Support

KM 1061 Uni Pro Seat & Suspension PN: 8528

NOTE: Installation kit has wiring harness or adapters included to allow plug and play on most applications.

NOTE: The KM 1061 comes equipped with an Operator Presence Switch. Some tractor models do not have OPS and the harness can be tied up and tucked out of the way.

1. Remove the original seat and suspension from the tractor by removing four ½ inch nuts from the base bracket attaching the seat to the floor of the cab.

2. Bolt the KM 1061 Uni Pro seat and suspension assembly to the pedestal PN 6127 using four 8mm x 20mm bolts, flat washers and flange nuts.

3. Attach seat and pedestal to the four stud bolts and spacers where the original seat was removed. Use the original hardware to fasten down the seat. Locate the power cable coming from lower part of suspension and connect to 10 amp 12 volt connection of the tractor.

Optional Swivel Kit Available PN: 5007