How to Install Your BreezeBy TransponderYour windshield serves as an antenna for the transponder to function at its best.

STEPS:

1. Clean the inside of your windshield thoroughly before installation.

2. For velcro attachment: Peel back the clear plastic on each velcro strip, leaving them attached to the transponder to ensure proper placement. For decal: Carefully peel back only the clear backing to avoid damaging the copper foil and chip embedded inside.

3. Place in the highest point of CLEAR glass (not shaded), just behind and to the right of the rear view mirror (see photo below). There must be clear glass surrounding the transponder.

4. DO NOT HOLD YOUR TRANSPONDER UP TO THE WINDOW IN YOUR HAND - this weakens the signal strength and may cause the gate to remain closed.

5. See reverse side for instructions on driving through the BreezeBy lanes.

How to Remove Your Decal Transponder

To remove a decal transponder, first peel off the transponder, scrape off any remaining residue, then clean the area with an alcohol wipe or windshield cleaner. Once you remove a decal transponder, you should not attempt to reuse it. However, you should save the decal - Breezeby customers can receive a $15 discount on a new transferable

transponder when they turn in an old decal transponder.

Questions? Call the Port of Hood River at (541) 386-1645 or email us at porthr@gorge.net

OPTIMAL PLACEMENT: ON WINDSHIELD, BEHIND OR TO THE RIGHT OF THE REAR VIEW MIRROR

ALTERNATIVE PLACEMENT: ON DASH, LAYING PERFECTLY FLAT AND SQUARE TO THE WINDSHIELD

1. Transponder must be horizontal. Even a slight tilt could cause the gate to stay down.

2. Place below any tinted glass.

1. Transponder must lay perfectly flat, horizontal to the windshield. Even a slight tilt or slant could cause gate to stay down.

2. Ensure their are no objects in the transponder’s line of sight to the reader.

BreezeBy customers can travel through any lane, but the outside lanes are for BreezeBy only.

The transponder reader is located well before the gate.

Your transponder must be in a readable position before approaching the toll plaza area.

Generally, this is the line where the asphalt turns to concrete.

Using the axle count reader loops and the transponder reader together, the electronic toll system will calculate and charge the appropriate toll to your BreezeBy account in the time it takes for you to travel under the reader and to the gate.

The traffic signals indicate your BreezeBy account balance is either sufficient (green), below the minimum $10 balance threshold (yellow), or at a negative balance (red.)

Questions? Call (541) 386-1645 or email porthr@gorge.net.

READER RANGE

READER RANGE

GATE

GATETOLL

HOUSE

AXLE COUNT LOOPS

AXLE COUNT LOOPS

SOUTH BOUND BREEZEBY LANE

NORTH BOUND BREEZEBY LANE

Using the BreezeBy Lanes