how to frame a deck
TRANSCRIPT
HOW TO FRAME A DECK
When it comes to framing a deck, you need to start by installing the ledger board to
serve as a reference for the rest of the deck. This is then followed by installing the
frost footings. Once these are done, you need to frame the perimeter of the deck by
making use of temporary supports. The order that needs to be followed in framing
the deck will be dictated by the design of the deck.
It is important to plan appropriately so that a smooth building process can be
obtained. Highlighting the individual forms on the plan will make it easier to select
the proper place to start. It is ideal to start the framing process against the house
since the ledger board provides a stationary surface, as well as length, to pull
measurements from, and also attach joists to. Also, ensure you finish one section of
your deck before you proceed to the next if your deck will change elevations. The
final steps that you will encounter in framing your deck are the stairs and landings.
The whole process is summarized below:
Make a Plan:
Before getting the hammer, you need to consider some things before you build
your new deck. Ensure you seek council approval, check for any underground
cable and pipe, and also decide on the design of your deck. These are some of the
things that you need to put into consideration.
Article Source:
http://www.mydenverroofers.com/uncategorized/frame-deck-denver-
colorado/