How to Fix Toilet Problems

When toilets work fine, they are fantastic but when they start causing problems like leaking or overflowing, they can prove to be nightmarish experiences. You can repair and fix these problems at home, without calling for professional help.

Get to know what is in your toilet

Even though most basic toilet mechanisms are the same, it is best to understand how your toilet works by examining the components. Plumbers usually make a small fortune by fixing these problems. There are few common problems that arise constantly with most toilets.

Bubbling toilets

If the waiter in your toilet bubbles even when you aren’t using it then there is a blockage in the plumbing pipes. Blockage will cause the water to back up and rise into the toilet. Apart from this, common piping in the entire building can also cause bubbling in toilets. To fix the problem you will have to carefully vent the pipes as inadequate venting causes back ups.

Running flush water problems

Sometimes, even after the flush cycle ends water continues to run and you will have to forcibly push the handle up again. It is considered to be one of many common toilet problems and is quite easy to fix. When you flush the toilet, lift the tank top off and check the valve flapper. Ensure that it isn’t caught anywhere. By doing so excess water running will be avoided after each flush.

Fix your noisy toilet

Few toilets experience a loud noise after the tank fill cycle ends. The noise occurs because of a cheap quality fill valve that is fitted in your toilet’s tank. Solution to this problem is to throw away the old valve and get a better quality valve fitted in the tank.

Fix your leaking toilet

Sometimes you will notice a brown stain left behind in the toilet bowl or dripping of water into the toilet bowl. The two washers situated at the top of the ball valve is the cause of this problem. What you will need to do is lift the lid of the cistern and undo the flush button.

The long tubular pipe in the cistern is the ball valve, which helps the water flow in and out of. It has a float attached to it. Once you undo the float, a pin will slide out. Some cisterns just lift straight off. The ball valve is the long tubular thing that the water flows up and out of. It has the float attached to it. Undo the float, it usually is held on by a pin at the end and slides out. You will have to take out the washers and get them exchanged for new ones to fix the leaking toilet.

http://ameriservatlanta.com/plumbing/