hazard communication plan copper mountain college
TRANSCRIPT
HAZARDCOMMUNICATIONPLANCOPPERMOUNTAINCOLLEGE
COPPERMOUNTAINCOMMUNITYCOLLEGEDISTRICT6162ROTARYWAY,P.O.BOX1398JOSHUATREE,CALIFORNIA92252
(760)366‐3791
PREPAREDBY:BRUCEW.BRIDENBECKERMay3,2016
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 1 HAZARD COMMUNICATION PLAN
Hazard Communication Plan I INTRODUCTION II HAZARD DETERMINATION PROCEDURES III LIST OF HAZARDOUS MATERIALS IV PROCEDURES A. LABELS AND OTHER FORMS OF WARNING B. INFORMING CONTRACTORS ABOUT HAZARDS C. CHEMICAL SPILLS AND ACCIDENTS D. CHEMICAL HANDLING, STORAGE, AND DISPOSAL V PERSONAL PROTECTIVE EQUIPMENT VI TRAINING VII APPENDIX A. SAFETY ADVISORY GROUP B. OSHA STANDARD 29 CFR 1910 SUBPART Z; Cal/OSHA Section 8, Subchapter 7, Group 16, Article 109, 5191 & 5194 (Links) C. MAP OF PHYSICAL PLANT AND LABORATORY FACILITIES
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 2 HAZARD COMMUNICATION PLAN
I. INTRODUCTION Copper Mountain College seeks to protect its employees from all unsafe exposures to hazardous chemicals known to be present in the workplace. Employees have a responsibility to learn and follow the procedures we have established to assure basic awareness of hazards and safe use of materials in our workplace. To ensure that all avenues are addressed, the following written hazard communication program has been established for all departments at Copper Mountain College. These plans are to be reviewed by the Chemical Hygiene Officer (CHO) at least every 12 months and updated as necessary to reflect significant changes in the status of our program. A list of the Safety Advisory Group (SAG) is contained in Appendix A. The SAG shall meet at least once a month to review safety, health and sanitation conditions. The SAG shall make recommendations concerning such conditions. Health or safety issues, which may particularly affect one (1) individual, shall be treated by the SAG with as much confidentiality as possible within the constraints of the obligation to investigate and, where appropriate, cure the concern. II. HAZARD DETERMINATION PROCEDURES In accordance with the OSHA standard, we will rely upon the chemical manufacturer to identify and evaluate the various hazards of the chemicals they supply to us. The Safety Committee will rely upon information provided on the Safety Data Sheet (SDS). The SDS is to identify all of the chemical characteristics as required by the OSHA standard. The Director of Facilities and Operations (DFO) or designee will insure that SDSs are readily accessible and that supervisors know their location. A. Department staff should see that each SDS sheet is reviewed when received to see that it contains the following information: * Identities used on labels * Chemical and common (generic) names * Physical and chemical characteristics * Physical hazards * Health hazards (signs & symptoms of exposure, medical conditions aggravated by exposure) * Primary routes of entry * Air exposure limits * Carcinogenicity * Emergency and first aid procedures * Date of preparation of SDS * Name, address and phone number of SDS preparer or distributor
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 3 HAZARD COMMUNICATION PLAN
* Any generally applicable precautions for safe handling and use that are known to the chemical manufacturer or employer preparing the SDS, including appropriate hygienic practices, protective measures during repair and maintenance of contaminated equipment, and procedures for clean-‐up of spills and leaks. * Any generally applicable control measures which are known to the chemical manufacturer, or employer preparing the SDS, such as appropriate engineering controls, work practices, or personal protective equipment. * The OSHA permissible exposure limit, American Conference of Industrial Hygienist (ACGIH) Threshold Limit Value, and any other exposure limit used or recommended by the chemical manufacturer or employer preparing the SDS. * Whether the hazardous chemical is listed in the National Toxicology Program Annual Report on Carcinogens (latest edition) or has been found to be a potential carcinogen in the International Agency on Cancer Monographs or by OSHA. B. The Department Staff will contact the supplier of any missing information. If the supplier does not respond within 30 days the purchaser will be notified to find a new supplier or the DFO will file a complaint with the local OSHA Area Office. C. The DFO or designee will coordinate necessary monitoring for any chemical in the workplace, which is questionable or required by law. Monitoring will be conducted in one of the following manners: (1) in-‐house using Copper Mountain College equipment and personnel or (2) by an independent consulting firm. III. LIST OF HAZARDOUS CHEMICALS All departments will keep a copy of the Hazard Communication Program, a list of all hazardous chemicals known to be present in the work place, and one hard copy of the SDS for each of the chemicals. A complete list of SDSs for all chemicals used within the College will be kept in Facilities and Operations. Further information such as the physical & chemical hazards of the chemicals, detection methods and protective measures for each chemical can be obtained by reviewing the SDS. Employees are entitled to a copy of the SDS if they so request. The list of all hazardous chemicals shall be subjected to cross-‐reference to the SDS for each listed chemical. IV. PROCEDURES FOR LABELING AND OTHER METHODS OF COMMUNICATION A. Labels and Other Forms of Warning. As of December 1, 1990, all containers in the workplace are to be labeled. The purpose of labeling each container is to properly identify the contents of the container so that the employee is warned as to what type of hazard (if any) the contents of the container present.
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 4 HAZARD COMMUNICATION PLAN
a. Since chemical manufacturers are required to label their containers, Copper Mountain College will use these labels as our primary means of labeling. Such chemical manufacturers are required to label their containers to meet OSHA standards. b. Chemicals removed from the original bottles will be identified by a label, which shall contain the name of the chemical, the date on which the label was prepared, and the initials of the person preparing the label. Solutions will be labeled with the identity of the solvent, the concentration of each of the solutes, the date on which the solution was prepared, and the initials of the person who prepared the solution. For those chemicals and solutions for which a significant fire, explosion, health, or carcinogenicity hazard exists, the label shall identify the hazard and the severity of the hazard. For each type of hazard with a solution, the hazard severity information indicated on the label shall be, for that hazard, the most severe hazard indicated on the SDS for any of the constituents of the solution. The SDS will be used in each case where a label is lost or illegible. c. The DFO or their designee within the respective departments will ensure that all containers of chemicals in the departments are correctly labeled. Any container, which does not have this information, may be returned to the supplier, at the supplier's expense. d. Each Department has the overall responsibility of ensuring that all containers of chemicals used in his or her department are correctly labeled. e. Labels are not to be removed from any container, or defaced in any manner. f. Empty containers are not to be re-‐used to store other materials unless the container has been cleaned, the old label removed, and a new label affixed in its place prior to its re-‐use. B. Informing Contractors about Hazards. To assist in evaluating potential exposures and to ensure that a contractor's employees are provided with information regarding potential hazards, prior to any contractor entering the work site the Director of Facilities and Operations, in consultation with the appropriate faculty or staff member, will notify the contractor of any potential hazards relating to chemicals. The Safety Committee is a resource for the Director of Facilities and Operations to use to assist in identifying any potential hazards in the work site. C. Chemical Spills and Accidents. a. Should a hazardous material spill or accident occur, immediate attention is required by the person causing the spill to minimize the spread of the spilled
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 5 HAZARD COMMUNICATION PLAN
material. It is then the responsibility of the person causing the spill to report the spill to their supervisor. Except for the most minor spills, the supervisor will then notify the Chemical Hygiene Officer or designee (please see the “Copper Mountain College Chemical Hygiene Plan") who will arrange for the cleanup of the spilled material. Outside help will be called in to clean up the spill when, the extent of the spill or the material involved in the spill are such that inside help is not capable of handling the situation. b. In the event of a hazardous material emergency inside a building, the fire alarm system is available to signal people to evacuate the building. This alarm system is tested annually by Facilities and Operations. As with all fire alarms, the Fire Department and Campus Security will be notified and appropriate corrective action taken. c. All laboratory operations are to be carried out in accordance with accepted laboratory practices to ensure the prevention of accidental spills. For chemical spills and accidents in the laboratory, please refer to the "Copper Mountain College Chemical Hygiene Plan". d. After the emergency, a Security Department "Incident Report" will be completed by the Security Department. All accidents or near accidents will be carefully analyzed by the Safety Committee and the recommendations arising from the analysis will be distributed to all who might benefit from the information. Also, as a follow up to any safety related Incident Reports, a written recommendation will be sent to the President/Superintendents Office and a copy filed with the Incident Report for a permanent record. D. Chemical Handling, Storage and Disposal. Materials will be stored, insofar as is practicable, in their original containers. Bottles of chemicals should be placed on the storage shelves in such a way as to minimize the danger of bottles falling off the shelf. Chemicals will be stored on the shelves by chemical property. Highly toxic materials will be stored separately from other chemicals in a room, which is locked when not in use. Flammable materials will be stored separately from other chemicals in special cabinets. All chemicals will be examined at least annually to determine the need for replacement and the integrity of the container and label. Amounts stored within a laboratory should be as small as practical and the chemicals returned to the storerooms as soon as the need for the chemical exists in the laboratory. The proper disposal of hazardous material wastes is necessary to protect people, plants, and animals from harm that could be caused by the improper and careless disposal of these wastes. Disposal of wastes shall conform to the regulations outlined in Appendix B of the Chemical Hygiene Plan.
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 6 HAZARD COMMUNICATION PLAN
V. PERSONAL PROTECTIVE EQUIPMENT Most personal protective equipment is provided by Copper Mountain College to employees when and where necessary. It is the responsibility of each employee to be certain that the appropriate equipment is worn as necessary. The assessment of any hazards associated with exposure to hazardous chemicals, which require the wearing of personal protective equipment is the responsibility of Copper Mountain College. It is the responsibility of each employee to wear personal protective equipment as provided by the College or as required by the College. Eye Protection: Appropriate eye protection will be worn by all persons, including visitors, where chemicals are stored or handled. For specific regulations see a copy of the "Copper Mountain College Eye Protection Policy" Appendix B of the Chemical Hygiene Plan. Hand Protection: Appropriate gloves will be worn when the potential for contact with toxic materials exists. Inspect the gloves before each use. For specific regulations see a copy of the “Copper Mountain College Skin Protection Policy” Appendix B of the Chemical Hygiene Plan. Lung Protection: Use appropriate respirator equipment when air containment concentrations are not sufficiently restricted by engineering controls. Inspect the respirator before use. For specific regulations see a copy of the "Copper Mountain College Respiratory Protection Policy" Appendix B of the Chemical Hygiene Plan. Miscellaneous: Use any other protective and emergency apparel and equipment appropriate. VI . TRAINING The College will provide employees with information and training on hazardous chemicals in their work area at the time of employment and whenever a new hazard is introduced into their work area. Annual refresher training will also be given. It is the responsibility of the Human Resources Department and the immediate supervisor of the newly hired employee to be certain he/she receives the initial training. Annual refresher training is the responsibility of the department supervisor. The Director of Human Resources, will provide each new employee with information about safety training. Each department supervisor will cover the specific safety data sheets (SDS), which apply to the new employee and will show where copies of them are located. The department supervisor will be provided the names of those employees who have successfully completed training. These records will be maintained by, the Human Resources Department.
COPPER MOUNTAIN COMMUNITY COLLEGE DISTRICT 7 HAZARD COMMUNICATION PLAN
Simply giving an employee a data sheet to read does not satisfy the intent of our program. Our training is to be an opportunity to explain to employees not only the hazards of the chemicals in their work area, but also how to use the information provided in our Hazard Communication Program. This training will be accomplished by the department supervisor in an on-‐the-‐job basis. Training will include an opportunity for employees to ask questions to ensure that they understand the information presented to them. Specifically, the training will include the following: a. The requirements of the applicable OSHA standard 29 CFR 1910.1200 and/or Cal/OSHA Title 8 Subchapter 7 Article 109. b. The operations in their work area where hazardous materials are present. c. Methods and observations that may be used to detect the presence or release of a hazardous chemical in the work area (visual appearance, odor, monitoring, etc.). d. The physical and health hazards of the chemicals in the work area. e. The measures employees can take to protect themselves from these hazards, including specific procedures Copper Mountain College has implemented to protect the employees from exposure such as appropriate work practices, emergency procedures, and personal protective equipment to be used. f. The details of this Hazard Communication Program; the location and availability of the written program; an explanation of the labeling system and the SDS; and how the employees can obtain and use the information. e. The engineering controls or administrative controls, which the College has provided to protect against any hazards to employees (if any). f. The personal protective equipment required for the employees specific job (if any). APPENDIX A SAFETY ADVISORY GROUP APPENDIX B OSHA STANDARD 29 CFR 1910 SUBPART Z; Cal/OSHA Section 8, Subchapter 7, Group 16, Article 109, 5191 & 5194 (Links) APPENDIX C MAP OF COPPER MOUNTAIN COLLEGE
Copper Mountain Community College District 8 Hazardous Communication Plan – Appendix A
Appendix A Safety Advisory Group The District shall maintain a Safety Advisory Group (SAG) comprised of two (2) members appointed by the District and two (2) members appointed by the Association (other bargaining units may have up to two (2) representatives as well). The SAG shall meet at least once a month to review safety, health and sanitation conditions. The SAG shall make recommendations concerning such conditions. Health or safety issues, which may particularly affect one (1) individual, shall be treated by the SAG with as much confidentiality as possible within the constraints of the obligation to investigate and, where appropriate, cure the concern.
Copper Mountain Community College District 9 Hazardous Communication Plan – Appendix B
Appendix B Links to Federal and State OSHA Guidelines Federal OSHA https://www.osha.gov/pls/oshaweb/owares.do_search?p_doc_type=STANDARDS&p_search_type=StandTextPolicy&p_search_str=1910.1450). Cal/OSHA http://www.dir.ca.gov/title8/5191.html http://www.dir.ca.gov/title8/5194.html
Copper Mountain Community College District 10 Hazardous Communication Plan – Appendix C
Appendix C Map of Physical Plant and Laboratory Facilities
Hazardous Communication Plan Signature Page Chemical Hygiene Officer Vice President Student Services/Academic Affairs/Chief Instructional Officer Director of Facilities and Operations Superintendent / President Board of Trustee Approval / Date