guide to sending a cerec connect case - express dental labopen the cerec connect software by...
TRANSCRIPT
Guide to Sending a Cerec Connect Case A step-by-step guide to submitting cases to your laboratory to create
Bridges, Implant Abutments, and Crowns from Digital Impressions
1
Open the Cerec Connect Software by selecting the shortcut on your desktop. This software is very similar to the regular Cerec 4.0 Software you use for scanning. The beginning processes of Cerec Connect are the same as Cerec 4.0. Once you have added the patient’s information:
1. Select the restoration type by selecting: a. Single Restoration b. Bridge Restoration
2. Select Tooth #’s
2
Next, select your restoration parameters.
1. Crown or Inlay/onlay 2. Full Contour or Veneered (PFM, PFG, PFZ)
3
Next, select your material preference.
4
Make your shade selections.
5
Select stump shade if needed.
6
Once you have selected all of your restoration parameters, you are now ready to scan. Remember, you can always go back and edit these parameters before sending your case to the laboratory.
7
Scanning your restoration:
1. Lower Jaw 2. Upper Jaw 3. Buccal 4. Add Category if needed (BioCopy, BioRefference, etc.)
8
Draw margins on the digital model.
9
Now you are ready to send your scan to the lab!
Sign into Cerec Connect
1. Enter your user name 2. Enter your password
10
Review your order and restoration information.
11
1. Select Your Laboratory 2. Select Your Desired Return Date & Time
12
1. Select Patient Gender 2. Enter patient age 3. Make note of any additional information of instructions 4. Upload any additional files (pictures, drawings, etc.)
13
At this point the lab case has not been sent to the laboratory yet, it is only in the online order cart.
Always make sure and click the “Submit Case” to send it to the laboratory. If the case is not submitted it will remain in a pending status and the laboratory will not be notified.
14
Once you select “Submit Case,” you are required to enter in your Username and Password to verify your order. This acts as a digital signature.
1. Enter Username 2. Enter Password 3. Click Okay
Your case has now been submitted.
15