specifications and design liable to modifications without prior notice

GS400K DIESEL GENSETMODEL GS400K

Stand-by Power @ 50Hz 352kW / 440 kVA Prime Power @ ¤Hz 320 kW / 400 kVA

Standard Features

General features :

Engine (VOLVO , TAD1242GE )Charge alternator 24 V , Governor:Electronic typeECUAlternator (LEROY SOMER , LSA472VS3 )Single bearing alternator IP 23 , insulation class H /HRadiator 50°C [122°F]°C max. T° air inlet with coolantcapSkid and vibration isolatorsDry type air filterMain line circuit breakerMicroprocessor control panel24 V battery, rack and cableIndustrial silencer (loose)User manual

Generator Ratings

Voltage HZ Phase P.F Standby Amps Standby RatingskW/kVA

Prime RatingskW/kVA

415/240 50 3 0.8 612 352 / 440 320 / 400400/230 50 3 0.8 635 352 / 440 320 / 400380/220 50 3 0.8 661 348 / 435 316 / 395240/120 50 3 0.8 1059 352 / 440 320 / 400230/115 50 3 0.8 1105 352 / 440 320 / 400220/110 50 3 0.8 1155 352 / 440 320 / 400200/115 50 3 0.8 1270 352 / 440 320 / 400

Stand-By ratings are available for the duration of any power outage. No overload capacity is specified at this ratings. Prime ratings are availableper BS 5514, DIN 6271, ISO-3046 and IEC 34-1 with 10% overload capacity one hour in twelve hours.

Conditions of sale

SDMO provides a full line of products with high qualityrecognized engines and alternators.Service and parts are available from SDMO distributors as asingle source of responsibility.

Each and every units is factory tested. All generator sets arealso prototype tested.Two years limited warranty , please refer to the conditionsterms . Five years extended are also available.

specifications and design liable to modifications without prior notice

ENGINE DATAManufacturer / Model

Cylinder ArrangementDisplacement

Bore and StrokeCompression ratio

Rated RPMPiston Speed

Max. stand by Power at rated RPMFrequency regulation, steady state

BMEPGovernor : type

VOLVO TAD1242GE , 4-cycle, Turbo , Air/Air DC6 X L

12.13L [740.2C.I.]131mm [5.2in.] X 150mm [5.9in.]

17.5 : 11500 Rpm

7.5m/s [24.6ft./s]387kW [519BHP]

+/-0. 5%23.9bar [346psi]

Electronic type ECUExhaust System

Exhaust gas flowExhaust temperature

Max back pressure

1050L/s [2225cfm] 505°C [941°F]

1000mm CE [39in. WG]Fuel System

110% (Stand By power )100% (of the Prime Power)

75% (of the Prime Power)50% (of the Prime Power)

Total fuel flow

89.6L/h [23.7gal/hr] 81.5L/h [21.5gal/hr]59.5L/h [15.7gal/hr]40.5L/h [10.7gal/hr]500L/h [132.1gal/hr]

Oil SystemTotal oil capacity w/filters

Oil Pressure low idleOil Pressure rated RPM

Oil consumption 100% loadOil capacity carter

35L [9.2gal] 2.5bar [36.2psi]5.5bar [79.7psi]

0.12L/h [0.0gal/hr]31L [8.2gal]

Thermal balance 100% loadHeat rejection to exhaustRadiated heat to ambiant

Heat rejection to coolant

250kW [14215Btu/mn]17kW [967Btu/mn]

123kW [6994Btu/mn] Air intake

Max. intake restrictionEngine air flow

500mm CE [20in. WG]416L/s [882cfm]

Coolant SystemRadiator & engine capacity

Max water temperatureOutlet water temperature

Fan powerFan air flow

Available restriction on air flowType of coolant

Thermostat

44L [11.6gal]103°C [217°F]93°C [199°F]

11 kW8.5m3/s [18012cfm]43mm CE [1.7in. WG]

Glycol-Ethylene82-95 °C

EmissionsHCCONox

PM

23 mg/Nm3256 mg/Nm31800 mg/Nm323.7 mg/Nm3

specifications and design liable to modifications without prior notice

ALTERNATOR SPECIFICATIONS

GENERAL DATACompliance with NEMA MG21, UTE NF C51.111, VDE 0530, BS4999, CSA standards.

Vacuum-impregnated windings with epoxy varnish.IP21 drip proof.

ALTERNATOR DATAManufacturer / Type

Number of phasePower factor (Cos Phi)

AltitudeOverspeed

Pole : numberExciter type

Insulation : class, temperature riseVoltage regulator

Sustained short circuit currentTotal harmonics (TGH/THC)

Wave form : NEMA = TIF – TGH/THCWave form : CEI = FHT – TGH/THC

Bearing : numberCoupling

Voltage regulation 0 to 100% loadRecovery time (20% Volt dip) ms

SkVA with 90 % of nominal sustained voltage (at 0.4 PF)

LEROY SOMER LSA472VS3 3

0.8< 1000 m2250 rpm

4SHUNTH / HR448

3 IN = 10s< 4%< 50< 2%

1Direct

+/- 0.5%500 ms

N/A

OTHER ALTERNATOR DATAContinuous nominal rating @ 40°C

Standby rating @ 27°CEfficiencies @ 4/4 load

Air flowShort circuit ratio;50 (Kcc)

Direct axis synchro reactance unsaturated (Xd)Quadra axis synchro reactance unsaturated (Xq)

Open circuit time constant;50 (T’do)Direct axis transient reactance saturated (X’d)

Short circuit transient time constant (T’d)Direct axis subtransient reactance saturated (X’’d)

Subtransient time constant (T’’d)Quadra axis subtransient reactance saturated (X’’q)

Zero sequence reactance unsaturated (Xo)Negative sequence reactance saturated (X2)

Armature time constant (Ta)No load excitation current (io)

Full load excitation current (ic)Full load excitation voltage (uc)

Recovery time (Delta U = 20% transitoire)Motor start (Delta = 20% perm. Or 50% trans.)

Transient dip (4/4 charge) – PF : 1.8 ARNo load lossesHeat rejection

466 kVA525 kVA93.3 %

1.1m3/s [2330.76cfm]0.29

405 %243 %

1771 ms22.8 %100 ms18.3 %10 ms24.7 %

1 %21.5 %15 ms0.9 A4 A40 V

500 ms973 kVA18.5 %

8.15 kW28.18 kW

specifications and design liable to modifications without prior notice

specifications and design liable to modifications without prior notice

Control Panels

TELYS Specifications :Frequency meter, Ammeter, Voltmeter

Alarms and faults Oil pressure, water temperature, No start-up,Overspeed, Min/max alternator, Min/max battery voltage, Low fuel level,Emergency stop Engine parameters Hours counter, Oil pressure, Watertemperature, Engine speed, Battery voltage, Fuel level

KERYS Specifications :Frequency meter, Ammeter, Voltmeter

Alarms and faults Oil pressure, water temperature, No start-up,Overspeed, Min/max alternator, Min/max battery voltage, Low fuel level,Emergency stop Engine parameters Hours counter, Oil pressure, Watertemperature, Engine speed, Battery voltage, Fuel level Additionalspecifications Website, Troubleshooting, Assistance and Maintenance,Plotting and logging, Load impact, 8 configurations available,Compliance with international standards...

M80 Specifications : Tachometer, Emergency stop

button, client connection terminal strip, EC certified Engine parameters :Hours counter, Oil pressure gauge,Water temperature indicator, Oil pressure indicator

specifications and design liable to modifications without prior notice

Options

Engine and Radiator Alternator Control panel

Anti condensation heater NFPA 110 level 1Heat shield protection Enforced impregnation Paralleling systemOil drain extension Oversized alternator Remote annunciatorHeavy duty air filter Oil temperature shutdown

Lube oil drain pump Exhaust Key start panelRadiator core guard Residential silencer LiteratureBattery charger Critical silencer PartsBlock heater Flexible exhaust conn. Maintenance

Fuel Enclosure M228

Day tank Silent 69.2 db @ 23 Ft (stby)Subbase fuel tanks UL

Water separator fuel filter

Weight and Dimensions

Open Model

Overall size l x w x h :3160mm [124in] x 1340mm [53in] x 1805mm [71in]

Weight :3238kg [7137lbs] Net 3718kg [8194lbs] Brut

With Optional Enclosure

Overall size l x w x h :4475mm [176in] x 1410mm [56in] x 2430mm [96in]

Weight :4320kg [9521lbs] Net 4790kg [10557lbs] Brut

specifications and design liable to modifications without prior notice

SDMO industries - Head Office – 12bis, rue de la Villeneuve – CS 92848 - 29228 BREST cedex 2 - FRANCE -www.sdmo.com