gravimetry
DESCRIPTION
Post precipitation, co precipitation, Gravimetric factorTRANSCRIPT
2
Gravimetric Analysis
Gravimetric analysis is the quantitative determination of analyte concentration through a process of precipitation of the analyte, isolation of the precipitate, and weighing the isolated product.
4
Gravimetric Analysis1. A weighed sample is dissolved
2. An excess of a precipitating agent is added to this solution
3. The resulting precipitate is filtered, dried (or ignited) and weighed
4. From the mass and known composition of the precipitate, the amount of the original ion can be determined
Types of Crucibles
• Different types of crucibles are used for drying and weighing the precipitates.
• They are mainly of two types.• Crucibles made of porcelain or silica are used when
the precipitates are dried in an oven or muffle furnace.
• Sintered crucibles are used for precipitates which are weighed after drying in air-oven.
Silica Crucible Porcelain Crucible
Sintered Crucible
The degree of contamination in gravimetric process
The types of contamination we come across in gravimetry is
• Co-precipitation and • Post-precipitation• Co-precipitation : Soluble impurities which are
getting precipitated along with the formation of the precipitate.
• Post-precipitation: After the formation of the precipitate, the impurities will get soluble.
Post-precipitation
Ca2+ (NH4)2C2O4 CaC2O4
• If Mg2+ is present as an impurity in Ca2+, then we can have a post precipitation of MgC2O4 over CaC2O4. The post precipitation can be avoided by keeping a high pH.
Example for co-precipitation • When estimating barium
Ba2+ + SO42– BaSO4
Contaminated with CrO42- BaCrO4
• The contaminants will go and get occluded inside the crystal lattice of BaSO4.
• Co-precipitation can cause erroneous results. • In order to minimise this co-precipitation we digest
the precipitate. • Digesting the precipitate in suitable solvent and
reprecipitation gives good yield.
Gravimetric factor• A gravimetric factor converts grams of a compound
into grams of a single element.• Example: To find the gravimetric factor of Cl– in AgCl
AgCl Ag+ + Cl–
Gravimetric factor =
=
= 0.24
AgCl of MassMolecular
Cl of mass –
143.3
35.5
⇌
Gravimetric factor
• Determine gravimetric factor of calcium in water, if you precipitate calcium as CaCO3.
Gravimetric factor =
= 40 100
= 0.4
3CaCO of MassMolecular
Ca of Mass
Factors which affect solubility of precipitate
• Temperature: heat is absorbed as most solids dissolve. Therefore the solubility of precipitates increases with increasing temperature.
• Solvent composition: The nature of solvent influences the solubility of most inorganic substances
• Diverse ion effect: Many slightly soluble salts show an increased solubility in the presence of increased concentration of certain salts having no ion in common with those of the slightly soluble salt.
