GeoProducts, LLCFor cost-effective performance -

is the logical choice worldwide

www.geoproducts.org

Landscape Architecture• Driveways• Gardens - natural - rock• Environmentally sensitive areas using native infill• Slope erosion• Cart Paths, Walkways• Maintenance Roads• Grass Parking Lots

Civil Engineering Construction • Landfill• Structural Supports, Foundations• Roadways, Walkways• Retaining Walls - Composite, Gravity, Free Standing• Pipeline & Sewer Support• Railroad Track Support• Water Crossings• Boat Ramps

Erosion Control• Re-vegetation (slopes)• Berms• Channel Liners• Scour Aprons/Drop Structures• Revetments• Shoreline Protection• Spillways/Chutes

Other Applications• Replace board roads for permanent roadways to

remote locations• Pipeline applications - support & erosion• Structural support for camps & heavy equipment• Levees• Field Parking Lots• Water Crossings

Projects completed on all continents

ENVIROGRID PROPERTIESMATERIAL: The polymer used to manufacture EnviroGrid shall be virgin, non-thermally degraded high-density polyethylene. The EnviroGrid strips shall conform to the following requirements:

MATERIAL PROPERTIES TEST METHOD UNIT TEST VALUEMinimum Polymer Density ASTM D-1505 g/cm3 (lb/ft3) .940 (58.7)Environmental Stress Crack Resistance ASTM D-1693 hrs 4000Carbon Black Content ASTM D-1603 % by weight 1.5% minimumNominal Sheet Thickness ASTM D-5199 mm (mils) 1.25 (50)+5%

SEAM STRENGTH:Peel Strength – 80 lb. (357 N) per inch of cell depth per U. S. Army Corps of Engineers, Technical Report GL-86-19-A

Report, Appendix A.

Seam Hang Strength – A 102 mm (4.0 in.) weld joint supporting a load of 72.5 kg (160 lbs.) for 30 days minimumor a 102 mm (4.2 in.) weld joint supporting a load of 72.5 kg (160 lbs.) for 7 days minimumwhile undergoing temperature change from 23°C (74°F) to 54°C (130°F) on a 1 hour cycle.

ASSEMBLY: Envirogrid is manufactured in three cell sizes

EnviroGrid panels can be provided in cell heights of 2” (50 mm), 3” (75 mm), 4” (100 mm), 6” (150 mm), 8” (200 mm), 10” (250 mm) and 12” (300 mm). Standard panels are constructed of 58 strips with thedimensions above.

Custom sizes and colors are available.

Available in solid or perforated cell wall.

259 mm10.2 in

224 mm8.8 in

320 mm12.6 in

287 mm11.3 in

508 mm20 in

475 mm18.7 in

EGA2O8.4' x 21.4' (2.56m x 6.52m)

EGA3O8.4' x 27.4' (2.56m x 8.35m)

EGA4O8.4' x 45' (2.56m x 13.72m)

Geo Products, LLC8615 Golden Spike Lane • Houston, Texas 77086281.820.5493 • Fax 281.820.5499800.434.4743 • www.geoproducts.org

Expanded

Collapsed

EGA2O (21.4') 6.52m

EGA3O (27.4') 8.35m

EGA4O (45') 13.72mAll Cell Sizes (8.4') 2.56m

3.6m (12') CellDepth

Cell Depth

CellWidth

127mm(5")

Geo Products provides this information only as an accommodation to our customers. No warranty or otherrepresentation regarding the suitability of the application procedure is made due to the fact that each installation has specific requirements that may not have been considered in this generalized procedure. Geo Products makes no warranties or representations regarding the suitability of its EnviroGrid for specific uses or applications. Our liability is limited to furnishing, without charge, a replacement for any EnviroGrid section that is proven defective under normal use and service.

Geo Products Quality System is registered to ISO 9001:2000