7/27/2019 Fuse Saving Blowing Schemes

1/2

Fuse saving schemes

Fuse saving schemes are used as a strategy to attempt to prevent permanent outages when

transient faults occur beyond tap fuses on a distribution system. Such schemes typically utilize

instantaneous overcurrent relays on the feeder breaker, which are set to be capable of sensing

faults beyond tap fuses on the associated line.

As such, faults beyond these fuses can be cleared by the feeder breaker prior to the fuse being

damaged. The low-set instantaneous relay typically is removed from service prior to the first or

second autoreclose of the breaker.

If the fault is permanent in nature, the fuse operates after the breaker autorecloses since the low-

set instantaneous relays are no longer in service and the time overcurrent relays are set to

coordinate with the tap fuses.

The coordination allows the fuse to blow without interrupting the whole feeder the second time.If the fault is transient, all customers are restored, including those beyond the fuse, when the

breaker initial autorecloses.

When fuse saving schemes are used, it is beneficial to autoreclose the feeder breaker as rapidly

as practical. Since, by action of these relays, the feeder breaker is allowed to operate for faults

beyond downstream protective devices, and on a significant portion of the feeder, fast

autoreclosing will mitigate the impact of more frequent breaker trips.

It is common practice at many of the utilities utilizing fuse saving schemes to employ immediate

autoreclosing (20 cycles of dead time to allow for deionization) on the first shot.

Often the low-set instantaneous overcurrent relays, or elements, are enabled just before resetting

the reclosing relay. By doing this, a low-magnitude fault, for which the time delay relays have

not completed their timing before the reset period of the reclosing relay expires, will be cleared.

If this is not done, the reclosing relay will reset and the reclosing sequence will be repeated a

number of times. Alternatively, many microprocessor relays take care of this problem by

blocking the reset timer whenever an overcurrent element is timing.

Fuse blowing schemes

Fuse blowing schemes are used to minimize the impact of a fault on the total feeder by allowing

a fuse time to interrupt a faulted lateral if the fault is on the customer side of the fuse.

In these schemes, a time delay sufficient for the fuse to operate before the upstream breaker is

tripped is added to the instantaneous overcurrent elements, or these instantaneous overcurrent

7/27/2019 Fuse Saving Blowing Schemes

2/2

elements are not in service during the initial trip of the feeder, and the time overcurrent elements

are set to coordinate with the fuse.

The instantaneous overcurrent elements are enabled into the tripping circuit following the

initial autoreclose attempt.

(From: http://powersystemprotectiverelaying.blogspot.ca)