fracking for 5g: reconfigurable rf and high-efficiency
TRANSCRIPT
Fracking for 5G: Reconfigurable RF and High-Efficiency Millimeter-wave Circuits to Find Elusive Spectrum Dr. James Buckwalter RF & Mixed-circuit Integrated Circuits Laboratory University of California – Santa Barbara
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Mixed-Signal and RF Integrated Circuits
• HSIC Lab at UCSB • Fundamental investigation of
RF and mixed-signal integrated circuit techniques that enable high-speed/high-frequency applications.
• 1 Post-doctoral Scholar • 10 Ph.D. Graduate Students • Alumni: • 8 Ph.D. Alumni, 3 M.S. Alumni
Silicon RF/ Microwave / Millimeter-wave
Wireline/ Silicon Photonics
High-Speed Mixed Signal
2
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Why UCSB ECE? • UCSB ECE MOVES DATA!
• Traditional strengths in • Photonics: backhaul and intra/interchip communication • High-speed, solid-state devices
• These strengths are complemented with an • Emphasis in wireless communication. • Emphasis on CMOS integrated circuits.
• Future integrated circuit technologies will leverage III-V and other material systems to enhance CMOS. UCSB is posed to develop leadership.
3
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Is Spectrum Inexhaustible? • Number of wireless devices vastly exceeds the world’s
population and is increasing rapidly!. • New devices are coming such as wearable electronics,
sensors, and radars. More devices in the same area.
1 EB = 1B Gigabytes • Traffic is projected at 5 EB per
month in 2015 • 01/20/14: British Telecom
demonstrates 1.4 Tb/s at 5.7 b/s/Hz; estimates 35% growth in bandwidth per year.
4
What drives increase in data demand? Cloud applications, Internet of Things 1) Data Center Traffic: Optical transport > 10 Tb/s 2) Mobile Content Delivery: Wireless > 1 Gb/s
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Beyond 4G?
• Look back at history licensed operation • 2G Cellular – launched in 1991
• Birth of GSM and CDMA in wireless communications • Maximum data rate (EDGE) of 1 Mb/s.
• 3G Cellular – launched in 2001 • Movement towards integrated data services over cellular • Maximum data rate (HSPA+) of 28 Mb/s.
• 4G Cellular – launched in 2011 • Transition to IP based communication • Extensive use of MIMO and signal processing • Peak data rates (currently) of > 100 Mb/s
• What’s next for 2021?
5
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
4H?
6
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Where will the CAPACITY come from? • RF: Evolution towards more fluid use of available
spectrum • Carrier aggregation • Simultaneous licensed/ unlicensed operation
• Millimeter-wave: Use of beamforming to exploit the spatial dimension for short wavelengths • 50 x BW in mm-wave bands • 5G 30 GHz bands • 60/140 GHz for short range • 70/80 GHz (E-band) for point-to-point links
7
Market does not jump to higher frequency bands until everything is squeezed from the lower frequency bands. Is it time?
Source: Qualcomm
Source: R. Heath
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Circuit Challenges for RF Hardware • Modern Cellphone 4G (LTE)
• Multiantenna / Multistandard / Multiband solutions • 1 W transmit, 20 MHz channels, OFDM (peak 300 Mb/s) • 700/850/1700/1900/2100/2600 MHz • WiFi, Bluetooth, Near-field
• How do you go 10X in existing bands? Most signal processing tricks have been exploited!
• MIMO è Massive/Multi-User MIMO (10x improvement possible) • Small Cells è Offload data traffic onto broadband network • Carrier Aggregation: Capacity expands with number of bands.
More bands, more interference. e.g. Qualcomm announces LTE-U chip for seamless use of LTE-A and unlicensed 5 GHz bands. 3x20 carrier aggregation.
• Software-defined Radios – ad hoc operation • Cognitive Radio: Sense (Spectrum), Discriminate (Blockers),
Mitigate (Interference), Learn (Patterns)
8
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Trends in IC Design
• RF (< 6 GHz) circuit design is blending with mixed-signal design techniques to produce reconfigurable circuitry/ software defined radios. Golden age for RF-CMOS Design!
• CMOS is pushing to millimeter-wave bands. Mm-wave/Terahertz systems are not necessarily limited solely by IC cost. Performance demands InP or GaN devices.
• Blending of heterogeneous IC processes: InP on CMOS or GaN on CMOS for phased arrays.
Everything starts with devices
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Conclusions
• Wireless access is reaching a tipping point. • Improvements in wireless capacity will require
digging deeper from within the congested RF spectrum for available spectrum.
• Opportunities to get plenty of spectrum at mm-wave bands at great cost to industry.
• At the same time, CMOS is reaching a point of diminishing return for scaling.
• Enhancing CMOS through materials and packaging approaches is a critical part of future mm-wave systems.
10
James Buckwalter, Corporate Affiliates Board Meeting, April 2015
Questions?