follow the standard procedures for moisture …...follow the standard procedures for moisture...
TRANSCRIPT
3 4 5
6 7 8 9
2 Tooth Pretreatment1
Post Cementation and Core Build-up
*5 Refer to the Table 3 for light-curing time. *6 Leave PASTE more than 6 minutes
after light curing when the thickness of PASTE is greater than the specified curing depth.
*4 Refer to the Table 3 for light-curing time.
Flow Chart Sheet
When CLEARFILTM Universal Bond Quick and CLEARFILTM DC CORE PLUS are used for bonding and post cementation
*3 You must start Step within 1 min.
02/2017
DUAL-CURED CORE BUILD-UP MATERIAL
CLEARFILTM
DC CORE PLUS
CLEARFILTM
Universal Bond Quick
Legal product name Abbreviatedproduct name
Halogen10 seconds
20 seconds
1.5 mm
2 mm
10 seconds
20 seconds
1.5 mm
2 mm
Type Curing time Curing depth
LED
PASTE
BOND
Table 3 : Relationship between curing time and curing depth for each dental curing unit
Table 1 : Legal product name and abbreviated product name used in this sheet
1621 Sakazu, Kurashiki, Okayama 710-0801, Japan
Indications003 1561R360R
Follow the standard procedures for moisture control, preparing root canal and try-in of the post.
b.Selective-etching
c.Total-etching
Dry by blowing mild air, and paper point until BOND does not move*1
[1]
For Glass Fiber Post
Apply a phosphoric acid, rinse and dry
5sec.
Post PretreatmentChoose either etching procedure
[1]
For Metal Post
Blast with alumina powder, then ultrasonic clean and dry
a.Self-etching ( Move to Step )
10sec.
10sec.
Apply BOND with a rubbing motion Light-cure*2
Squeeze PASTE*3 Insert the post and light-cure PASTE*4
Place PASTE around the post
Light-cure PASTE*5,*6
from both the lingual and the labial (buccal) sides
Apply a phosphoric acid to the uncut and/or cut enamel, then rinse and dry
Apply a phosphoric acid to the entire cavity (enamel and dentin),then rinse and dry
*1 Use a vacuum aspirator to prevent BOND from scattering.
No waiting time5sec.+
[2 ] Apply BOND , then dry by blowing mild air
5sec.Dry
The effective wavelength range of each dental curing unit must be 400-515nm.
* Peak of emission spectrum:450-480nm
Table 2: Dental curing unit and curing time
Halogen
LED
Lightsource
Type
Halogenlamp
More than400 mW/cm2 10 seconds
10 seconds
5 seconds
800-1400 mW/cm2
More than1500 mW/cm2
BlueLED*
Light Intensity Light-curingtime
*2 Refer to the Table 2 for light-curing time.
3
7