FOLDABLE ZENITH DRONE WITH FPV WI-FI CAMERA KAZENTDRONA & KAZENTDBATA

WARNING

• Read these instructions thoroughly before use.

• Do not discard of these instructions.

• Improper operation may cause serious personal injury or property damage.

• The product is not suitable for children below 14 years of age. It is not a toy.

• Ensure the device is operated with care at all times, and used only as directed in these instruction.

• The flight site must be a legal remote control model flight site. Check the rules and regulations for your local area before operating this device.

• Do not operate near crowds of people.

• Assess all potential obstacles prior to operation. This includes, but is not limited to, high-rise buildings, power lines, traffic, etc.

• Do not operate in extreme heat or cold weather. Suited only for use in 0° - 40° C temperatures.

• Do not use during high wind or rain. Check weather conditions prior to operation.

• Do not operate around bodies of water (lakes, creeks, etc) or damp ground. Water damage to the device may cause component failure, resulting in safety risk. Keep the device dry at all times.

• Do not touch the high-speed rotating parts (propellers) while in use.

• Do not operate the device if it is damaged. In the event of damage, discontinue use immediately and contact help.kogan.com for assistance.

Battery Safety This device contains a Lithium Polymer (Li-Po) battery. As such, extra care should be taken to avoid risk of property damage or personal injury.

• Do not operate while charging battery.

• Remove battery when not using for long periods of time.

• Do not leave battery in device when fully charged or above 50%.

If disposing of this product, take care to dispose of the battery correctly. Do not throw battery in general waste. Please take the device to a recycling centre and ensure the battery is recycled separately. For further information, please contact your local council office or waste disposal service.

SAFETY & WARNINGS

Number Name Qty Number Name Qty

1

Main body cover

x1

8

Protective frame

x4

2

Main body under cover

x1

9

PCB board

x1

3

Propellers

x4

10

Motor

x4

4

Front left arm

x1

11

Gear

x4

5

Front right arm

x1

12

Battery

x1

6

Rear left arm

x1

13

USB Charger

x1

7

Rear right arm

x1

14

Camera Board

x1

COMPONENTS

Remote Control

OVERVIEW

Photo / Video

360 Degree Roll / Emergency stop

ON / OFF Switch

Speed switch

Backward micro adjusts

Forward micro adjusts

Leftward micro adjusts

One key landing

One key takes off

Rightward micro adjusts

Headless mode / One key Return

1. Remote Control Battery

Insert batteries in remote control, paying attention to the battery polarity (+/-) as per the illustration below.

2. Connect the USB cable to the computer to charge To charge the device, connect the battery plug to the USB charging cable, and insert the USB end into a computer or compatible USB adapter. The indicator light will be on when charging, and off once full. Do not leave on charge when full.

3. Connecting the drone power supply Put the charged battery into the battery holder of the drone and then connect the power supply’s battery plug to the vehicle socket for power connection.

INSTALLATION

Note: Refer to the battery safety information in this guide’s Safety & Warnings page.

Switch

1. Folding function When folding, begin by folding each arm at the centre point and then folding the complete arm toward the body as one. When expanding, complete the same steps in reverse.

2. Arm and propeller installation The ‘A’ arms should be installed to the upper left and the lower right corners of the drone. The ‘B’ arms should be mounted to the upper right and the lower left corners of the drone.

At the corner of each arm, install the propellers.

ASSEMBLY

3. Protective frame installation Position the protective frame at the drone’s arm and install fastening, as per below image. Repeat these steps for all four arms.

Please note, the drone will not lift off if the protective frames are not securely attached. Ensure they are tightly installed before operating the device.

4. Attaching remote control thumbsticks The remote control will arrive with the thumbsticks separate, as shown below. To attach, simply line the joystick shafts up with each pad and press firmly to secure.

1. Install mobile phone client

Please scan the corresponding QR code to download and install the app.

Open in web browser (Apple iOS and Android)

Google Play Store (Android)

2. Operation instruction Enter the Settings, open the Wi-Fi option and find the device Wi-Fi hotspot name “YD_XXX_UFO_XXXXX” and connect. After successful connection, return to the desktop, open the downloaded app and enter the program.

INSTRUCTION

Remote Control 1. Mobile phone rack Pull out the remote control lower bracket to clamp the phone.

2. Turning on Place the drone on a flat surface, and then turn the power switch on. The drone indicator light will flash.

Turn on the remote control, push the throttle joystick to the highest and then pull to the lowest. You will hear a “tick” sound. The drone indicator light is on, match the right frequency to complete (2.4G frequency), then you can take off.

If unable to take off, ensure that the installation and assembly steps have been completed as specified in this guide. Check that the protective frame is tightly secured to each arm.

3. One key to start; One key to land Tip: This product is determined by the barometer. In a variety of environmental temperature and other factors, the drone will automatically start.

One Key landing mode when flying or low voltage. Appear high and low changes are normal.

OPERATION

One key takes off One key landing

4. Flight Control A. Throttle (left lever)

Push the left lever upwards

Drone rises

Push the left lever down Drone descends

B. Forward and backward (right lever) (with camera front side)

Push the right lever upwards The aircraft is advancing

Push the right lever down The aircraft is backwards

C. Left and right-side fly

Push the right lever to the left The plane flew to the left

Push the right lever to the right The plane flew to the right

D. Turn left and right (with camera front side)

5. Fine-tuning control (with camera front side):

Turn the left lever to the left

Aircraft turn left

Aircraft turn left

Turn the left lever to the left

Partial Rear Partial Front

Forward and backward fine tuning

Take off when the body forward offset, after the micro adjustment is correct

Take off the body when the offset, according to the former micro adjustment is correct

Directional definition, selecting headless mode Headless Mode sets the front of the drone to be in one direction, regardless of the orientation of the drone. Typically, you will activate headless mode so that the 'front' of the drone is facing away from you. If the drone pivots to the side, for example, the front of the drone will still be considered directly in front of you.

As an example, if the drone turns ninety degrees to the left, the right side of the drone, which is furthest from you, becomes the drones 'front', and when you direct the drone forward it will still move away from you, but in actuality, it is moving to the side.

When Headless Mode is activated, push the right lever to forward to have the drone fly away from you, regardless of its orientation. Pull the right lever to back, the drone will fly towards you.

To activate Headless Mode, first set the drone in front of you, with the camera facing away from you in line with the remote.

Take off the body when the left shift, according to the right micro adjustment is correct

Take off the body when the right shift, according to the left micro adjustment is correct

Left side Right side

About fine tuning

Front Head Forward

Once you are ready, press the Headless Mode button on the top left of the remote.

Once you take off, the flight heading will be set.

When flying in headless mode, the remote control will play a “flute” sound twice to indicate. The drone lights flashes. Press the remote controller button, a “flute” sound prompts and exits Headless Mode.

One Key Return One Key Return Mode returns the drone by travelling backward from its current position.

Because it travels backward, it is best used in conjunction with Headless Mode, otherwise, it is essential that the drone is orientated away from you before One Key Return is activated.

To activate One Key Return, press the button on the top of the remote

Speed Selection The drone has three speed settings, to cater to all pilots skill levels. By default, the drone will be set to the slowest speed.

To change the speed, press the top right button on the remote. It will play a “flute” sound twice to indicate the speed is set to the mid-level.

Press three times to activate the fastest speed. Press again to return to the slow speed setting.

It is highly recommended that beginners operate the drone at a slow speed.

Note: Using the right control thumbstick will cease the One Key Return function.

The Remote Controller The photo/video button, or the mobile phone app, can be used to take pictures or record video. You can view your video on your mobile and also start filming video or tale pictures through the app using Wi-Fi.

Wi-Fi aerial version of the phone can find Wi-Fi connection and remote control to start the video or take pictures.

When there is no connection to the app, you can use the SD card for later viewing.

Drone Reset Settings The reset setting is a horizontal reset of the six-axis gyroscope on the drone and the micro-adjustment of the remote control.

Push the sticks to the bottom right for 2 seconds, as the picture shows. You will hear a flute sound, and the drone will flash quickly a few times to indicate that the reset is successful.

Note: This function is generally not necessary, and should be used only for drone maintenance adjustment or when drone faces a serious offset.

Emergency landing: 1. During the flying time, if it needs an emergency stop, press the button (as picture

shows), the drone will stop working. (Please do not attempt this operation while the drone is flying in high altitude)

2. When the drone leans over 45 degrees, it will stop to protect the engine.

3. When using the app to control the drone, slide the throttle down and press the one key take-off button for an emergency landing.

Interface:

Button instruction:

1. Return 8. Switch 15. Emergency stop 21. Throttle

2. Take photo 9. Extra Settings 16. Landing 22/23. Left/Right roll

3. Record video 10. Camera flip 17. 360 rolls 24/25. Forward/Backward

4. Media 11. VR mode 18. Marking flight 26/27. Left/Right

5. Speed level 12. Headless 19. Speech Recognition

28/29. Forward/Backward trim

6. Gesture photo 13. Gyro calibrate 20. Lens pitch angle control (camera without servos does not respond by pressing this button)

30/31. Left/Right roll trim

7. Gravity control 14. Take off 32/33. Left/Right trim

Gravity sensor mode: Click on the icon to enter the gravity sensor mode, after entering the mode successfully, the icon shows the yellow indication, so that you can shake the phone to control the drone forward, back, left fly, the right side fly. Click the icon again to return to normal mode.

Take pictures: Control the direction to the drone to the location where you need to take pictures; click the camera icon, each shot a picture. After shooting, control the direction of the remote bar to change the camera target. Each time the camera takes 0.5-1 seconds to take a picture.

Note: Before using this feature, you must be skilled to operate the drone.

Voice command control-axis drone Turn on the drone power switch, click on the high icon in Figure 1 and then click on the button in Figure 2 for Voice command control.

Figure 1

Figure 2

Note: The camera lens of the drone indicates the front of the drone.

Push up the left joystick (throttle), the main motor speed increases, the drone rises.

Push down the left joystick (throttle), the main motor speed decreases, drone descends.

Left push the left joystick (throttle) to turn left the drone and push the left joystick to the right (throttle) to turn right the drone.

Push the right joystick up (rudder) to move the drone forward and push down the right joystick (rudder) to move the drone backward.

Descend

Rise

Turn Right

Turn Left

Forward

Backward

Push the right joystick to the right (rudder), to move the drone right side and the right joystick (rudder) to left to move drone left side.

If the drone rotates clockwise while in take off, adjust the right-hand fine-tune key until it returns to normal.

Fly right

Fly left

Note:

Push the left joystick (throttle) to take off. When the drone is turned in the air or laterally, uses the fine adjustment function to correct the action.

If the drone rotates counterclockwise while in take off, adjust the left rotation fine-tuning key.

If the drone drifts directly to the left when taking off, press the right side to fine-tune the key until it returns to normal.

If the drone drifts directly to the right when taking off, press the left side to fine-tune the key until it returns to normal.

If the drone is moved backwards, press the forward-tune key until it returns to normal.

If the drone moves forward, press the back-tune key until it returns to normal.

Note: When the drone is less than 30cm from the ground, it may be affected by magnetic currents generated by the ground and become unstable. The lower the drone attempts to fly, the greater the ground effect force.

Symptom Cause / Issue Solution

The drone batteries are inserted and the five indicator lights are flickering.

Remote control and drone connection are not successful

Please re-perform the remote control and the flying drone connection

The drone batteries are inserted and the five indicator lights stop flickering. The drone has no response.

Check if the remote control and the flying drone are powered on. Check whether the remote control and the drone battery are in a low power state. Is the battery positive and negative terminal or placed correspondingly.

Turn on the remote control and insert the drone battery. Use full charged battery. Reinsert the battery and confirm that the battery positive and negative pole piece of contact is normal.

When the throttle lever is used, the motor does not turn and the drone does not fly. The indicator light on the disc starts flashing.

Lithium battery power shortage.

Charge the battery or replace with another fully charged battery.

The drone main rotor continues to run but cannot take off.

The main rotor deformation. Drone battery power shortage.

Replace the main rotor. Charge or replace the battery with another battery.

The drone is not level. The main rotor deformation. Replace the main rotor.

The flying drone will still go on or on after moving. The gyroscope is not at all right

Drone engine malfunctioned.

The remote control can be automatically corrected or restart the re-frequency. Ensure that the drone is placed on a flat ground surface before take-off. Do not launch the drone from an incline or from hand.

The drone was not stable and fell.

Drone will not take off. Protective frame is not secured tightly.

Re-perform assembly and installation steps, ensuring protective frame is secured.

TROUBLESHOOTING

NOTES

NOTES

Need more information? This is a Quick Start Guide and we hope that this

has given you the assistance needed for a simple set-up. For the most up-to-date guide for your product,

as well as any additional assistance you may require, head online to help.kogan.com