8/8/2019 Focus Audio

http://slidepdf.com/reader/full/focus-audio 1/291

 © 2000 SCOSCHE INDUSTRIES, INC. ALL RIGHTS RESE

FOR MORE INFORMATION VISIT www.scosche.OR CALL SCOSCHE INDUSTRIES, INC. AT 800-363

REMOVE REAR SUPPORT

MODIFY CAVITY 

MINI STAN DIN ISO DIN

TUNERS / CASSETTE / DISC PLAYERS RADIO

EQ

STACK SINGLEDBL DIN

APPLICATION KIT MODEL: FM1375/FMC1370

HARNESS ADAPTOR: FD02 ANTENNA ADAPTOR:  VWA 

IN-DASH INSTALLATION AREA DIMENSIONS

DEPTH WIDTH HEIGHTMAX 

DEPTH

CAVITY  81/2" 81/

2" 71/8" 311/

16"

TYPE: PLASTICDASHOPENING

DASH MATERIAL: PLASTIC THICKNESS:

FOR MAX DEPTH

AMPLIFIER/EQ MOUNTING LOCATIONS (WxHxD)

UNDER/IN UNDER GLOVE TRUNK/DASH SEAT BOX CARGO

13 x 51/4

x 20" 111/2

x 57/8 x 61/

8" Various

K5 = WHEN EQUIPPED WITH STANDARD TWO SHAFT RADIO/TAPE PLAYER. FABRICKIT WHEN EQUIPPED WITH FLAT FACE ELECTRONIC RADIO/TAPE PLAYER.

KS = SCOSCHE KIT RECOMMENDED.N = NOT RECOMMENDED. EXTENSIVE MODIFICATION REQUIRED.P = PERFECT WITHOUT MODIFICATION.P1 = MODIFY OR REMOVE POCKETS.P2 = COIN POCKET LOCATION IN DASH (MAY REQUIRE TRIM KIT).P3 = PERFECT WHEN EQUIPPED WITH STANDARD TWO SHAFT RADIO, K WITHOUTR = REAR LOAD ISOMOUNT.U = UNDERDASH.W1 = WITH POWER WINDOWS ONLY.W2 = WITHOUT POWER WINDOWS ONLY.

IN DASH APPLICATION NOTES

CHASSIS H 13/4-2 2 2 2 37/

83

CHASSIS W 71/8

71/8

71/8

7 71/8

71/8

CHASSIS D 43/4-51/

257/

8-611/

1657/

8-611/

1657/

8-611/

1657/

8-611/

1657/

8-611/

16

NOSE H 15/8-13/

415/

8-13/

423/

8113/

1633/

4-4

NOSE W 41/8-43/

1641/

8-43/

1671/

2611/

16611/

16-71/

4

SHAFT SP. 51/8-53/

451/

8-6

   N   O   T   E  :   T   H   I   S   M   A   N   U   A   L   I   S   B   A

   S   E   D

   O   N

   C   A   R   E   F   U   L   L   Y   D   O   C   U   M   E   N   T   E   D

   R   E   S   E   A   R   C   H .   A   B   S   O   L   U

   T   E

   A   C   C   U   R   A   C   Y   I   S   A   T   T   E   M   P   T   E   D

   B   U   T   N   O   T   G   U   A   R   A   N   T   E   E   D .   U   S   E   T   H   I   S   M   A   N   U   A   L   A   S   A   R   E   F   E   R   E

   N   C   E

   G   U   I   D   E .   S   C   O   S   C   H   E ,   I   N   C .   C   A   N   N   O   T   B   E

   R   E   S   P   O   N   S   I   B   L   E   F   O   R

   I   N   C   O   N   S   I   S   T   E   N   C   I   E   S   T   H   A   T   M   A

   Y

   O   C   C   U   R .

K S K S K S N N K 4

B = BACK UP PLATES REQUIRED.C1 = CUT TRIM/PLASTIC (STRUCTURE).C2 = CUT STEEL.D = BELOW DECK ONLY.D1 = LIFT PORTION OF DECK. (MAY REQUIRE STRUCTURAL REINFORCEMENT).D2 = CUT STEEL WHEN TOP MOUNTED. DO NOT IF BELOW DECK.D3 = NARROW SURFACE, BELOW DECK ONLY.F1 = MINIMUM MODIFICATION FILE SHAFT HOLES OR DASH OPENING.F2 = MODIFY DASH CAVITY AND/OR PANEL.K = INSTALLATION KIT, SPACER OR ADAPTOR REQUIRED.K1 = KIT MODIFICATIONS REQUIRED.K2 = EXTENSION KIT RECOMMENDED.K3 = WHEN EQUIPPED WITH FACTORY "ELECTRONIC" RADIO.K4 = FABRICATE PANEL/BRACKETS.

FORD2000-UP FOCUS4 Door Sedan / Wagon, 3 Door Hatchbac

Dimensions shown are inches.

For inch/mm conversions refer to chart section.

UPDATEDTHROUGH2001

2002

2003

2004

FRONT DOORSFactory Provisions: "

K =SA68

6 x 8

Aftermarket: 5 / "K , 6 / K , 6 x 8"1 s 1 S

4 2s

"

CAVITY W H D5 / x / x 2"

1

4 471

DASH WITH SCOSCHE FMC1370 KIT INSTALLED.

REAR SIDE PANELS - HATCHBACK

Factory Provisions: 6 x 8"

K =SA68Aftermarket: 5 / "K , 6 6 x 8"

1 S

4S

1 S / "K ,2

CAVITY W H D

5 / x 7 / x 2 / "1 1 1

4 4 2

xx

REAR DOORFactory Provisions:Aftermarket:

CAVITY W H D

6 x 8"5 / "K , 6 / "K , 6 x 8"

1 s 1 s

4 2

K = SA68s

5 / x 7 / x 2 / "1 1 1

4 4 2

-SEDAN,WAGONS

8/8/2019 Focus Audio

http://slidepdf.com/reader/full/focus-audio 2/292

 © 2000 SCOSCHE INDUSTRIES, INC. ALL RIGHTS RESERVED

FOR MORE INFORMATION VISIT www.scosche.comOR CALL SCOSCHE INDUSTRIES, INC. AT 800-363-4490

DASH WITH RADIO/TRIM REMOVED. FRONT DOOR PANEL.

REAR DOOR PANEL.

REAR SEAT SIDE PANEL SPEAKERS.

PRELIMINARY : DISCONNECT THE NEGATIVE BATTERY CABLE.

ANTENNA: THE FACTORY ANTENNA IS LOCATED IN THE CENTER FRONTOF VEHICLES ROOF.

RADIO REMOVAL AND IN-DASH INSTALLATION: NOTE: THE FACTORY RADIO PROVISION IS A CUSTOM FORD DOUBLE

DIN. WHEN INSTALLING AN AFTERMARKET DIN STEREO A DASH KITIS NEEDED. WE RECOMMEND THE SCOSCHE FM1375 OR FMC1370INSTALLATION KIT. A SET OF DIN REMOVAL TOOLS IS ALSO NEEDEDTO REMOVE THE FACTORY HEAD UNIT. WE RECOMMEND THESCOSCHE DT-1 FORD DIN REMOVAL TOOLS.

1. INSERT FORD DIN REMOVAL TOOLS TO RELEASE CLIPS, PULL OUTSTEREO, DISCONNECT AND REMOVE.

FRONT DOOR SPEAKER INSTALLATION: NOTE : THE FACTORY SPEAKER PROVISION IS FOR A 6 X 8” SPEAKER.

 WHEN INSTALLING AN AFTERMARKET 5 ¼ OR 6 ½ SPEAKER, ASPEAKER ADAPTER IS REQUIRED. WE RECOMMEND THE SCOSCHESA68.

1. EXTRACT (7) T-15 TORX SCREWS FROM THE PERIMETER OF DOORPANEL.

2. REMOVE SCREW COVER FROM DOOR OPENER CUP, AND EXTRACT (1) #2 PHILIPS HEAD SCREW FROM BEHIND.

3. USING A PANEL REMOVAL TOOL, UNSNAP THE SIDE MIRROR INTERIORTRIANGLE PANEL, LIFT AWAY AND REMOVE.

4. UNSNAP COVER FROM DOOR HANDLE, AND EXTRACT (2) #3 PHILIPSHEAD SCREWS FROM BEHIND RADIO.

5. UNSNAP TOP CONTROL PANEL, LIFT AWAY DISCONNECT AND REMOVE.6. PULL DOOR PANEL UPWARDS AND REMOVE.7. EXTRACT (4) # 2 PHILIPS HEAD SCREWS FROM SPEAKER, DISCONNECT

AND REMOVE.

REAR DECK SPEAKER INSTALLATION: NOTE: THE FACTORY SPEAKER PROVISION IS FOR A 6 X 8” SPEAKER.

 WHEN INSTALLING AN AF TERMARKET 5 ¼ OR 6 ½ A SPEAKER

ADAPTER IS REQUIRED. WE RECOMMEND THE SCOSCHE SA68.

1. EXTRACT (7) T-15 TORX SCREWS FROM THE PERIMETER OF DOORPANEL.

2. REMOVE SCREW COVER FROM DOOR OPENER CUP, AND EXTRACT (1)#2 PHILIPS HEAD SCREWS FROM BEHIND.

3. REMOVE TRIANGLE PANEL AT TOP FRONT SIDE OF DOOR PANEL.4. UNSNAP COVER FROM DOOR HANDLE AND EXTRACT (2) # 3 PHILIPS

HEAD SCREWS FROM BEHIND.5. UNSNAP CONTROL PANEL, LIFT AWAY DISCONNECT AND REMOVE.6. PULL DOOR PANEL UPWARDS AND REMOVE.7. EXTRACT (4) # 2 PHILIPS HEAD SCREWS FROM SPEAKER, DISCONNECT

AND REMOVE.

2000-UP FORD FOCUS4 DOOR SEDAN, WAGON, 3 DOOR HATCHBACK