HorseBy Louis

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

Final

This tutorial will guide you through using a stencil to create a horse using thin lines to look like a3D sketch. It will take one stick of �lament to make the horse, and one more if you want to make the accessories on the second stencil.

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

HorseBy Louis

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

Step 1 Step 2

Step 5 Step 6

Step 3 Step 4Lift up one of the smaller body pieces, hold it over the main body piece and connect them togther like so.

Print out the stencil and trace the pieces. If the pieces are too flimsy go back over them.

Work your way around the edges moving back and forth between the body shapes.

Attach the other side of the body in the same way.

Attach the legs to the outer body pieces. Make the sure the hooves are all even so the horsewill stand.

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

HorseBy Louis

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

Step 7 Step 8

Step 9 Done!Get mythical with a steed fit for a demigod!If you want, use the 2nd stencil to make a horn,

wings, or alternate legs!

Add the horn to make a unicorn! Make your ownpieces to personalize it! Does your horse have a wild mane? Maybe a saddle! Or battle armor!

Like always, this is just to get you started. What canadd to make it your own?

HorseBy Louis

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

Stencil

HorseBy Louis

the3Doodler.com/Community | Copyright WobbleWorks, Inc. 2014

Stencil