equipment for engineering education & research bernoulli’s...
TRANSCRIPT
SOLTEQ®
BERNOULLI’S THEOREM
DEMONSTRATION
MODEL: FM 24
THIS Bernoulli’s Theorem Demonstration (Model: FM 24) apparatus consists of a classical Venturi
made of clear acrylic. A series of wall tappings allow measurement of the static pressure distribution
along the converging duct, while a total head tube is provided to traverse along the centre line of the
test section. These tappings are connected to a manometer bank incorporating a manifold with air bleed valve.
This unit has been designed to be used with a
Hydraulics Bench for students to study the
characteristics of flow through both converging and
diverging sections. During the experiment, water is
fed through a hose connector and students may control
the flowrate of the water by adjusting a flow regulator
valve at the outlet of the test section.
The venturi can be demonstrated as a means of flow
measurement and the discharge coefficient can be
determined.
This test section can be used to demonstrate those
circumstances to which Bernoulli’s Theorem may be
applied as well as in other circumstances where the
theorem is not sufficient to describe the fluid behaviour.
EXPERIMENTAL CAPABILITIES
♦ Bernoulli’s Theorem and its limitations
♦ Measurements of the static and total head
distribution along a Venturi tube
♦ Meter coefficient at various flow rates
Equipment for Engineering Education & Research
SOLTEQ
TYPICAL EXPERIMENT RESULT
Actual Flow Rate Versus Ideal Flow Rate
0
5
10
15
20
25
0 5 10 15 20 25
Ideal Flow Rate, Qi (LPM)
Act
ual
Flo
w R
ate,
Qa
(LP
M)
SPECIFICATIONS
Manometer : 0 to 300 mm, 8 tubes
Venturi : Throat dia.: 16 mm
Upstream dia.: 26 mm
Upstream taper: 14°
Downstream taper: 21°
Flowmeter : max. 20 LPM
REQUIREMENTS
Hydraulics Bench ( FM 110 )
SOLTEQ®Equipment for Engineering Education & Research
Our range of teaching equipment can be complemented with our
SOLDAS and SOLCAL software.
SOFTWARE & E - LEARNING
SOLDAS® - Supervisory Control & Data Acquisition
- Data Logging
- Signal Analysis
- Process Control
- Real-Time Display
- Tabulated Results
- Graph of Experimental Results
SOLCAL® - Computer Aided Learning
- Multimedia Features
- Interactive
- Graphic Simulation
- Experiment Result Samples
- Full Experiment Manuals
SOLTEQ®
Contact us for a catalog CD
SOLUTION ENGINEERING SDN. BHD.(Co. No. 174876-M)
Sales Office :
No.3, Jalan TPK 2/4, Taman Perindustrian Kinrara,47100 Puchong, Selangor Darul Ehsan, Malaysia.Tel. No. : +(603) 80758000Fax. No. : +(603) 80755784
R&D Office :
G-2A, Incubator 3, Technology Park Malaysia,Bukit Jalil, 57000 Kuala Lumpur, Malaysia.Tel. No. : +(603) 8996 0023
Email : [email protected] site : http//www.solution.com.my/
AGENT:
Equipment for Engineering Education & Research
BUATAN MALAYSIA
MSC- StatusCompany