ep-55 installation&operation update10-30lib.store.yahoo.net/lib/853111/newvictorelock.pdfbolt...
TRANSCRIPT
Step2
Adjust the dead bolt
Adjust the latch
bolt by pushing
hole.
Lift pin and pull the
body to the right.
2-3/ 8”
2-3/ 4”
60mm
70mm
2-3/ 8”
2-3/ 4”
Step3
Install latch bolt and dead bolt, making certain both latch
bolt and dead bolt hub are center to center.
Step4
Storeroom Function allows the latch to be locked at all times. Every time you
close the door the lock will lock automatically. To throw the deadbolt on storeroom
function, use the remote control and then lift the lever handle.
Passage/Entrance Function unlike the storeroom function, the door will
remain unlocked after each opening.
Make certain dead bolt is at retracted position.
Insert the spindle from
the outside of door to
the spring latch hole.
Step7
Place the outer lock
body to engage with
the spindle in
alignment (the cam
clutch smoothly
engages with the
spindle, align both
inside and outside
housings to ensure
proper installation.
Step9
Tailpiece
Right door swing
Left door swing
Direction of tailpiece, vertical (RIGHT
HAND), horizontal (LEFT HAND),
for door swing
Step11
Tailpiece
X
Engage tailpiece through
dead bolt hub.
Correct position for the wire
harness
Wrong position for the wire
harness (that will stop the
movement of tailpiece)
Step12
Make certain sandwich plate screws are
tight (this will prevent shifting of both
outside and inside plates)
Flat head screws
Round head screws (longer
than other 4 round head
screws)
Step13
Connect with wire harness.
In assembly, make certain wire harness is
located under the inside housing.
Step19
●●●● Final Operation Test
■■■■ Lift Lever Handle from inside and outside to lock Dead Bolt.
Confirm door cannot be opened from outside.
■■■■ WHEN LOCKING DOOR LIFT LEVER HANDLE ALL THE
WAY UP. If Lever Handle is only lifted partially, door may not
lock.
■■■■ Egress exit by pressing down Lever Handle.
■■■■ Do not use chemicals or abrasive materials to clean lock.
Insert battery housing with,
batteries into the inner lock
(make certain batteries are in
the correct direction)
■■■■ Lock Door from Inner Lock
Unlock Door
Lift up lever handle to
lock door
Press down lever handle
to unlock door
■■■■ How to use emergency key
Cam Lock Push the key into key hole
and hold it firmly and then
rotate down to unlock door
Please disconnect the battery
pack for 2 minutes whenever
you use the emergency cam
lock and reset it.
Specification and Operation
●●●● Interconnected dead bolt and lever lock.
●●●● Stand alone 4 AA batteries.
●●●● Low battery warning indicator.
●●●● Green Light: Access Code Accepted
●●●● Orange Light: Low Battery
●●●● Passage/Entrance or storeroom function at your choice(included in this lock).
●●●● 4 AA batteries not included.
● How to lock door
Just lift up lever handle to lock door.
● How to unlock door
Enter correct code (****1 2 3 4 5 6 #) and then press down lever
handle to unlock door