engineer training machine new features tj8300 / tj8500 machine new features
TRANSCRIPT
Confidential 2
Engineer Training
Machine New Features
TJ8300 / TJ8500Ruler for Media Position
Located on the top plate of the loader.
The ruler location is compared to the drum and enables easy measurement of the media position.
Confidential 3
Engineer Training
Machine New Features
TJ8300 / TJ8500Ruler for Media Position (Cont.)
Compared to the Drum
Confidential 4
Engineer Training
Machine New Features
TJ8300 / TJ8500Ruler for Media Position
The machine has the following 4 safety interlocks:
Front door
Right door
Loader
Rear window
Confidential 5
Engineer Training
Machine New Features
TJ8300 / TJ8500Media Length Sensors
Located on the right side of the unloader.
Measure the loaded media length and warns on “too short” loaded media length.
Confidential 6
Engineer Training
Machine New Features
TJ8300 / TJ8500Bridge Temperature
The TJ850 UV ink needs to be warmed to 30°C when the machine is working. The TJ851 UV ink needs to be warmed to 34° +/- 1°C.
The standby temperature when turning Off the machine is 26°C.
In order to achieve the stable temperature, the bridge heaters have been changed and their working voltage is now 40VAC.
Confidential 7
Engineer Training
Machine New Features
TJ8300 / TJ8500Ink Bars Heater Plate
There is an optional ink bar heater plate for site areas that are too cold.
Located below the Ink bars.
Controlled by temperature controller.
Heats the ink bars to 30°C (for TJ850 UV ink) or to 34° +/- 1°C (for TJ851 UV ink).
Confidential 9
Engineer Training
Machine New Features
TJ8300 / TJ8500Temperature Controller
Controls the Ink bar heater plate.