endicott brick details
DESCRIPTION
Brick masonryTRANSCRIPT
BRICKCONSTRUCTIONDETAILS
endicot t .com
T Y P I C A L F O U N D A T I O N D E TA I L S
C H I M N E Y C A P D E TA I L
T Y P I C A L S E C T I O NA N D F L A S H I N G D E TA I L
T Y P I C A L L I N T E L , J A M B A N D S I L L D E TA I L S
T Y P I C A L E A V E D E TA I L S
2-Hour Fire Rated Brick Veneer Wall Assembly
Typical brick veneer wall assemblies have fire ratings of up to 2 hours. The figure above shows a typical
brick veneer wall assembly with a 2-hour fire rating.
F I R E R E S I S TA N C E
4"Min Lap
8"MinRise
1” Air Space
8d Nail
22-Guage GalvanizedCorrugated Metal Tie
• Every Stud Horizontally• Every 24” Vertically
Brick Veneer
Open Headjoint Weepholes• 24” Centers
Wick Weepholes• 16” Centers
or
1/2” Cement Parging
Bituminous Water Proofing
Wall Base FlashingProject Flashing 1/2”
Wood Studs @ 16”Centers Horizontally
Gypsum Board
Sheathing
Insulation
Weather Resistant Membrane(15# Building Felt)
Sub Floor
Sole Plate
Floor Joist
Header
Sill Plate
Anchor Bolt
Full Collar Joint
Foundation Wall
BRICKVENEERWALL
TYPICAL BRICK MASONRYMORTAR JOINTS
W E A T H E R I N G R E G I O N S
E n d i c o t t R e c o m m e n d e d W e a t h e r i n g I n d e x e s i n t h e U n i t e d S t a t e s
Used to attach brick veneer to wood frame backup
Used to attach brick veneer to metal studs
Same as (b)
Used to attach brick veneer to structural steel
Used to attach brick veneer to concrete backup
Same as (e)
Used to attach brick veneer to masonry backup
Same as (g)
Severe Weathering
Moderate Weathering
Negligible Weathering
*Note: Endicott Clay Products does not recommend Struck, Flush, Raked or Extruded mortar joints.
*
* * *
a
d
g
b
e
h
c
f
a
d
g
b
e
h
c
f
T Y P I C A L T I E S F O R B R I C K V E N E E R
EMPIRICAL HEIGHT LIMITATIONS FOR BRICK VENEER
Nominal Thickness of the Brick Veneer, in (mm) Stories Height at Plate, ft (m) Height at Gable, ft (m)
3 (75) 2 20 (6.10) 28 (8.53) 4 (100) 3 30 (9.14) 38 (11.58)
Endicott Clay Products CoP.O. Box 17Fairbury, Nebraska USA 68352402/729-3315 FAX: 402/729-5804
Endicott Tile LLCP.O. Box 645Fairbury, Nebraska USA 68352402/729-3323 FAX: 402/729-5804
[email protected] endicott.com
ENC-BCD-0410
Endicott has been building one success story after another all across the U.S.
The unique clays found only in Jefferson County, Nebraska, make it possible for Endicott to produce a wide variety of face brick, pavers, tile, thin brick and special shapes that are nationally recognized for their quality and aesthetic beauty.
Endicott products are distributed throughout the United States. For literature, samples and the name of your nearest distributor, contact Endicott today.
S I N C E 1 9 2 0
Try our new Masonry Designer and Virtual Mason now at endicott.com
FOR FURTHER EXPLANATION REGARDING THE INFORMATION IN THIS BROCHURE, REFER TO BIA TECHNICAL NOTES ON BRICK CONSTRUCTION.