electrical system instruments and components. alternating current an alternating current (ac) is an...
TRANSCRIPT
Electrical System
Instruments and components
Alternating Current
An alternating current (AC) is an electric current whose direction reverses cyclically, as opposed to direct current, whose direction remains constant. The usual waveform of an AC power circuit is a sine wave, as this results in the most efficient transmission of energy. However in certain applications different waveforms are used, such as triangular or square waves.
Phase
• Alternating currents are accompanied (or caused) by alternating voltages. An AC voltage v can be described mathematically as a function of time by the following equation:
where
Vpeak is the peak voltage (unit: volt), ω is the angular frequency (unit: radians per second)
– The angular frequency is related to the physical frequency, f, which represents the number of oscillations per second (unit = hertz), by the equation .
t is the time (unit: second).
Phase
A sine wave, over one cycle (360°). The dashed line represents the root mean square (RMS) value at about 0.707
3-Phase
One voltage cycle of a 3-phase electrical system, labeled 0 to 360° along the time axis. The plotted line represents the variation of instantaneous voltage (or current) with respect to time. This cycle will repeat 50 or 60 times per second, depending on the power system frequency.
Transformers A transformer is a
device that transfers el ectrical energy from
one circuit to another through inductively cou
pled electrical conducto rs. A changing current
in the first circuit (the primary ) creates a changing magnetic field . This changing
magnetic field induces a changing voltage in the second circuit (the secondary ). This effect is called mutual induction.
http://en.wikipedia.org/wiki/Transformer
2-phase transformer
Oil immersed transformer
Distribution
Domestic distribution
Three-phase distribution
Question
• Show by sample calculation why smaller cables can be used for long-distance power transmission when very high voltages are used
สถาปนิ�กควรค�านิ ง• Transformer area แรงส�ง• Distance from main line สายส�ง• MDB Room ไม่�ควรอย��ใต้�ดิ�นิ แรงต้��า ม่� meter,
main switch, Zone’s DB 0.6*0.9*2.00 m
• LC, PB ,ม่� Shaft
• Floor to floor (height), Plenum space, Attic