drivbiwire vnt15/17 repair procedure - tdi club...
TRANSCRIPT
1
Drivbiwire VNT15/17 repair procedure Tools needed: T-20 Torx 10mm Box end wrench 17mm Box end wrench Steel Drift Heavy weight hammer High temperature (1700°F/ 930°C) or greater Pick Green Scotch-Brite Emery Cloth
2
Remove VNT Actuator and the retaining circlip
3
4
5
Soak it well!!!, patience you may need to wait overnight!
6
7
Always replace oil line!
8
9
10
11
12
DO NOT hit the ALUMINUM!!! Verify with every hit you are on the cast iron bearing housing!!!
13
14
15
2 Oclock position With turbo laying on it’s side
16
17
18
19
20
21
Most common area that jams the VNT rotating ring…
22
23
24
One area of concern regarding soot
25
Use pick and get all the carbon and rust out of corners…
26
DO NOT scratch or sand this area. Use Green Scotch-Brite to get carbon off face.
27
Clean the VNT face of all soot residues using Green Scotch-Brite…
28
Raised spacer, maintains clearance and acts as a contact point between VNT control ring and Turbine housing
29
30
31
32
33
34
35
Note clearance, or lack there of…excessive soot build up is a bad thing
36
37
Carb and Choke cleaner plus Scotch-Brite
38
39
40
41
Pick all the rust from the bearing housing groove
42
Alignment Pin
Internal VNT ring actuator Rod
43
Emery Cloth to remove
44
Alignment Pin hole
Note wear ring wear marks
45
46
High Temp Anti-Seize to hold spacer in place
47
Spacer Rings
48
Note housing and Alignment pin postion
Insert Guide vane plate then insert screws thru the plate and thru the spacer rings, make sure spacer rings did not fall out of position!!!
49
Insert VNT Rotating ring
50
Make sure all Guide vanes are visible with slot aligned with screw
51
Insert Spacers and pins
52
53
54
Check Guide Vane alignment
55
High temp Anti-Seize
56
Alignment pin inserts into alignment hole
57
Anti-Seize
58