WARNINGThis product must be wired as described below. Read these instructions fully and carefully.

GENERALRF - Thank you for purchasing a quality SI-LITE product. This product has been designed, developed and tested to our strict codes & standards. This product is designed to be powered by a power supply - for 12v either SI-LITE model SP05; SP07; SP09or SP10; for 24v either SP02 or SP04.

IMPORTANT INFORMATIONInstallation should be carried out in accordance with IEE wiring regulations. Always disconnect the mains supply before installa-tion. Connect the driver to the mains supply ensuring that it is protected by a fused connection unit. Make sure all electrical connections are tight. Install the fitting as described below.

ASSEMBLY INSTRUCTIONS

Installation / Usage Instructions RF-DIM

FEATURESRF - Radio Frequency Dimming ControllerFor control / dimming of 12v and 24v LED single colour ribbon tapeIP 20Input voltage 12-24v DCWorking temperature -20 to 60 degrees1 channel outputOutput power: 12v <96w; 24v <192wOn/off and Mode buttonsDims LED ribbon down to approx. 5% brightnessNOTE: remote control requires 1 x 12v 27a battery (not included)

1. Connect the red / positive wire from the LED strip live end to the red (+) OUTPUT terminal, and connect the black / negative wire from theLED strip live end to the black (-) OUTPUT terminal.2. Connect a red (positive) wire to the red (+) INPUT terminal from the chosen LED driver, and a black (negative) wire to the black (-) INPUTterminal from the LED driver. Ensure all connections are secure and that a short circuit cannot occur between connecting wires.

3. Introduce the chosen power supply to the mains supply (110-240vAC) (following power supply instructions). The LED’s will illuminate.4. Use the fob to control the light output:On/off button - press once to turn the LED strip on or off.

The fob clip can be attached to a key ring / hook when not in use.The control unit memory will retain the brightness level is use when the LED strip was previously turned off.

The control unit can be wall mounted.

This unit is compatible with SI LITE 12v or 24v LED strip. It has been designed to control LED strip in isolation, and not in conjunction withan external lighting control system.

Press to increase brightness to desired level.Press to dim brightness to desired level.