Download - PPT BAMBANG
PLANETARY GEARSPLANETARY GEARS
Chapter 4 Page 61 Classroom Manual
PLANETARY GEARS & SHAFTS
PLANETARY GEARS & SHAFTS
Describe how different gear ratios are obtained from a planetary gear set.
Identify components of a planetary gear set & their operation.
Describe the different designs of compound planetary gear sets.
Describe the construction and operation of typical Simpson gear train.
INTRODUCTIONINTRODUCTION
Automatic Transmissions provide different gear ratios for performance and economy over the entire driving range.
Ratios are selected manually (driver) or automatically (hydraulically).
A planetary gear set consists of a sun gear, a planet carrier, internal gear.
Page 61
SIMPLE PLANETARY GEAR SETS
SIMPLE PLANETARY GEAR SETS
Planetary gear sets are typically helical cut gears.
Sun gear is in the center. Planet gears rotate around the sun gear. The Ring, Annulus, or Internal gear is the
outer gear of the set.
Page 61
SIMPLE PLANETARY GEAR SETS
SIMPLE PLANETARY GEAR SETS
Page 61
SIMPLE PLANETARY GEAR SETS
SIMPLE PLANETARY GEAR SETS
Planet gears are in constant mesh with the Sun and Internal gears.
Number of planet gears depends on the load the transmission was designed for.
A planet gear set can provide (1) gear reduction, (2) overdrive, (3) direct drive, (4) reverse, or a (5) neutral position.
Page 62
SIMPLE PLANETARY GEAR SETS
SIMPLE PLANETARY GEAR SETS
When a smaller gear drives a larger gear, output speed is decreased.
When a larger gear drives a smaller gear, output speed is increased.
When a external gear drives another external gear, output direction is reversed.
Page 63
SIMPLE PLANETARY GEAR SETS
SIMPLE PLANETARY GEAR SETS
When a external gear is in mesh with an internal gear, the two gears will rotate in the same direction.
Clutch packs and bands are used to hold or release the members of the planetary gear set to get the proper direction of rotation and/or ratio.
Page 63
GEAR REDUCTIONGEAR REDUCTION
When the output gear turns at a slower speed then the input gear, gear reduction has occurred and results in increased torque output.
2 ways to get reduction Hold sun gear, drive internal gear. Hold internal gear, drive sun gear. Lower
ratio. Page 63
OVERDRIVEOVERDRIVE
When output speed is greater than input speed, overdrive is achieved.
2 ways to get overdrive. Hold sun gear, drive planet carrier. Hold internal gear, drive planet carrier.
Higher ratio overdrive.
Page 64
DIRECT DRIVEDIRECT DRIVE
Input and output speed are the same. Drive any two members of the planet and
the result is direct drive.
Page 64
REVERSEREVERSE
Input rotation direction is reversed. 2 ways to get reverse. Hold planet carrier, drive planet carrier. Hold planet carrier, drive sun gear. This
is reverse overdrive.
Page 64
NEUTRALNEUTRAL
Input but no output. When no member of the planetary set is
held or locked to another, there will be no output regardless of which member receives the input.
Page 65