Download - PPC LDF4 Install Inst_Hand Tool
6176 East Molloy Road • East Syracuse, NY 13057-0278 • Tel: 315-431-7200 • Fax: 315-431-7201 • E-mail:[email protected] • www.ppc-online.com
Innovate. Connect.
Installation Instructions
Center Conductor
Cleaner
KIT-HCG-1/2 Tool Kit
CC-DM-L4
CC-NM-L4
CC-DF-L4
CC-NF-L4
CC-NRA-L4
Step #1
Step #2
Safety Glasses
Always wear
safety glasses
when operating
tool
Insert for
N, R/A or DIN type
1/2” Frame Set
HGC Tool
A. Straighten cable and
position cable cutter in valley
of corrugation and cut off the
cable square.
B. Use strip/prep tool to strip
and cut cable.
A. Rotate clockwise until cable
hits fi xed stop on tool. Remove
cable from tool.
B. Properly stripped and cut
cable is ready for dielectric
removal.
SP-1/2-LDF4
Prep/Strip Tool
C. Remove stripping tool
REV 8.0
Compression connectors for Andrew LDF4-50A & RFS LCF12 foam coaxial cable
With a few simple steps, PPC compression connectors can be easily and consistently installed
6176 East Molloy Road • East Syracuse, NY 13057-0278 • Tel: 315-431-7200 • Fax: 315-431-7201 • E-mail:[email protected] • www.ppc-online.com
Innovate. Connect.
Installation Instructions
Step #4
A. Align outer conductor to back cap. Mark cable jacket with marker in line with end of the connector.
B. Push connector onto cable until it reaches mark (you
should hear a series of clicks). Be sure connector reaches mark
on cable.
Step #5
C. When fully compressed, connector cap will completely cover o-ring
A. Pull or push back the insert to allow connector/cable to lay fl at in frame.
B. Make sure connector is fully seated in frameset (lying fl at). Press tool trigger to compress the connector. Do not push on tool/cable during compression.
D. Use the right torque wrench for the interface to connect the port or mating connector.
Frame
Insert
Ma
rk i
s st
ill
he
re
Connector Frame Set Insert
CC-DM-L4 Insert A
CC-DF-L4 Insert A
CC-NRA-L4 Insert A
CC-DRA-L4 Insert A
CC-NM-L4 Insert B
CC-NF-L4 Insert B
Step #3
B. Use center conductor cleaning
tool to remove any dielectric on
center conductor
A. Core cable to remove
dielectric until cable reaches
stop on tool.
foam removed
REV 8.0
Compression connectors for Andrew LDF4-50A & RFS LCF12 foam coaxial cable