MOBILE DENTAL NOG TYPES USED IN
WORKING DENTAL MODELS
Julija Vladikova, Cena Dimova, Hadis Arslanov, Pavle Apostolski
UNIVERSITY “GOCE DELCEV”
FACULTY OF MEDICAL SCIENCES
STIP - MACEDONIA
INTRODUCTION: A working dental model is a model made from the mold taken from an intervention inthe mouth (in the fixed prosthetics that is preparation of the teeth) and on which it is directly modeled anda fixed prosthetic construction is made. We pour a hard or super hard plaster. The mold is made first bymixing the super hard plaster, a small quantity is poured on the protruding part of the mold (distal part ofthe palate) by tapping in slowly it slides in the lumen of all the molded teeth. In this way the water and airare squeezed out so there aren’t any defects or porosity on the molded movable dental nog.
Key Words: Apparatus, dental nog, dental prosthetics,models, modern methods
RESULTS: Today the dental model making isimperative, and the whole laboratory making of theartificial dental crowns taken from the working models(knows as “master” models) are mobile nogs that can betaken out of the rest of the mold mutable times and againput back in the completely same position.
The reason is that, the removed nogs very easy toapproach, model and control the precision of thegingival edge of the artificial crown, especially fromthe mesial and distal side where there is a chance of asmall gap.The second reason is that some particular widelyaccepted models for making an envelope as the firstphase of the modeling of the crown (for example:making an envelope by wrapping it in plastic foil alsoknown as the Adapta-system or a model made bydipping in molted wax) they can be made only if theworking nog is not mobile.In a working dental model is made with a mobile nog,there are a number of ways of making that: with Neymetal stakes, Trey- model- system with tray leadinggrooves and with separation, with root continuancefrom plaster or peg, with galvanization, with a mobileperiodontium (his regards the surrounding gingival, andnot directly on the movable working log.)By using the Pindex apparatus we can drill channels inthe plaster for placing double (Duplex) stakes, by usingthe Top Spin (automatic laser drill) a laser drill is makeand placement of the stakes for making movable dentalnogs in the dental practice.
AIM: The goal of the study is to explore methods and apparatus for making models with movable dental nogs
and their use in today’s modern practice.
CONCLUSION: By using different methods andapparatus in the dental practice we get workingmodels with movable dental nogs which securebetter retention, stabilization and orientation forrightful acting.
International
Symposium
24 November 2015,
Stip,
Macedonia
MATERIAL and METHOD: For realization of the set goal a research was made and information wasgathered from different manufacturers of apparatus and methods for making models with movable dentalnogs.
