Download - Hybrid wireless protocols
![Page 1: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/1.jpg)
Hybrid Wireless Network Protocols
Prepared by :- Mohammad Abdelhadi Mohammad Mustafa
Khaled Melhem
![Page 2: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/2.jpg)
Outline :-
● Introduction.
● What is Hybrid Wireless Network.
● Proposed Protocols.● One hop Direct transmission.● Two hop Direct transmission.● Handoff Procedures.
● Simulation Results.
![Page 3: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/3.jpg)
Introduction.● Wireless networks are of two types :-
● Base station-Oriented Wireless Network.○ Single-hop that requires fixed Base Station.○ Better performance.○ More Reliable.
● Ad Hoc Wireless Network.
○ Doesn't have any centralized administration.○ MHs depend on each other for communication.○ Low cost.○ High flexibility.○ Bandwidth usage and battery power consumption are
more efficient.
![Page 4: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/4.jpg)
![Page 5: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/5.jpg)
Introduction● Problems in BS-oriented wireless network.
○ BS failure problem
![Page 6: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/6.jpg)
Introduction● Problems in Ad Hoc Wireless Networks:-
○ Rerouting caused by mobility. ● Disrupted Connection.
![Page 7: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/7.jpg)
What is the Hybrid Wireless Network?
● Hybrid Wireless Network can act as a bs-oriented or ad hoc network at any given time according to the environment conditions.
● Made by adding Base stations to Ad hoc Network.● Has the advantages of both Ad-hoc and Base stations.● Mobile nodes communicate with each other using Ad Hoc
mode when they are in range, and use basestation to communicate when they are out of range.
● More efficient and reliable.● Flexible with seamless handover.
![Page 8: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/8.jpg)
What is the Hybrid Wireless Network?
![Page 9: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/9.jpg)
Proposed Protocols
● The Protocol for One-Hop Direct Transmission.
● The Protocol for Two-Hop Direct Transmission.
![Page 10: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/10.jpg)
Direct Transmission
● Is the situation where two MHs communicate directly or use a third MH as a relay without the help of base station.
● The sender broadcasts the connection request message.● All devices within the sender's signal covering area would
receive this message ( including the BS).● Each MH receiving the message will check the destination
ID.● If the destination ID matches itself, The transmission
procedure begins.● When the destination moves out of the covering area, the
BS would have to take over (BS-Oriented Mode)
![Page 11: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/11.jpg)
The Protocol for One-Hop Direct Transmission.
● Sender broadcast a SEARCH message.● If the receiver is within the range and finds out the
destination is itself, it responds with ACK message to the sender.
● The BS also receives the SEARCH message and it sends the SETUP message to the destination.
● if the destination sends the DIRECT message to the BS, the communication will be direct between MHs.
● Otherwise, if the destination sends an ACCEPT message to the BS, the communication will be BS-oriented mod.
● The Continuity of the communication of the two modes depends on the distance between the communicating pair.
![Page 12: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/12.jpg)
One-hop direct transmission mode
![Page 13: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/13.jpg)
The BS-oriented mode
![Page 14: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/14.jpg)
Handoff Procedure
● Direct transmission mode:○ if the destination detects that the signal strength is less
than the threshold value, handoff must be executed.○ The destination sends the CHANGE message to its
sender.○ The sender receives the CHANGE message and it sends
the SEARCH message again, then BS-oriented mode will be used or two-hop mode.
![Page 15: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/15.jpg)
Handoff Procedure
● BS to One-hop direct transmission:○ If the receiver detects that it is within the coverage region
of the sender's signal and the signal is strong enough, it has the option to switch from the BS-oriented.
○ The receiver sends the CHANGE request to the sender.○ The sender sends the SEARCH message out.....Direct
transmission steps.○ After the sender receives the ACCEPT message from the
receiver, it sends a TearDown message to the BS and breaks the connection.
![Page 16: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/16.jpg)
BS-oriented handoff
![Page 17: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/17.jpg)
Protocols for Two-Hop Direct Transmission Mode
● Cover wider area than the one-hop.● allow two MHs to communicate through a third MH acting as
a relay.● Each MH must implement a Neighbor Database.● A disrupted connection could occur.● Two is the optimal number for hops to avoid the routing
problems that could occur with more than two hops.
![Page 18: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/18.jpg)
Two-Hop Direct Transmission Mode
● This situation happens when the communicating pair are both within an intermediate's coverage area.
● The sender transmits data to the receiver through an intermediate MH.
● If a MH is in the sender range there are two cases:○ When it is the receiver, it sends ACCEPT message back
(One-hop direct transmission).○ If it is NOT the receiver, it will check the neighbor data
base, if the destination is in its data base, it forward the SETUP message, and sends ACCEPT back to the sender if the connection is accepted.
![Page 19: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/19.jpg)
Two-Hop Direct Transmission Mode
● The destination only accept one copy of the SETUP message.
● At the same time, the BS would receive the SEARCH
message. It queries the MH and sends the SETUP message to the destination. For direct transmission, the destination receives the SETUP message and sends the DIRECT message to its BS. Otherwise, the destination would accept the connection from the base station.
![Page 20: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/20.jpg)
Two-Hop Direct Transmission Mode
![Page 21: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/21.jpg)
Handoff Procedure
● if the destination or the intermediate node finds that the strength of the signal is less than a critical value, the handoff procedure is requested and executed at this time. The system will try to find another direct transmission path.
● If a direct transmission path is not found, the BS-oriented mode will take over. The handoff procedures are listed as follows.○ The destination or intermediate node sends the
CHANGE message to the sender for changing connection.
○ As the sender received theCHANGE request, it re-initiates the connection by sending out SEARCH. The next several steps are the same as in the initial connection setup.
![Page 22: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/22.jpg)
Simulation Results
![Page 23: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/23.jpg)
Simulation Results
![Page 24: Hybrid wireless protocols](https://reader034.vdocuments.site/reader034/viewer/2022042700/558656fcd8b42ace3e8b45bc/html5/thumbnails/24.jpg)
Thank you for listening!Any Questions?