meet your drilling needs
COMPACT PILING RIGS
Why Geax DTC ?HIGHER OVERALL RIGIDITY
COMPACTNESS ALLOWS TO BE AGILE ON SITES
NOISE REDUCTION DURING SPIN OFF
THE ARTICULATION OF THE MAST PERMITS TO REACH MANY DIFFERENT WORKING CONFIGURATIONS
POSSIBILITY TO WORK ON SEVERE SLOPES AND WITH HIGH SIDE TILT
POSSIBILITY TO DRILL UNDER SEVERE OVERHEAD LIMITS
AS AN EXCAVATOR CAN REACH ALMOST ANY DIFFICULT ACCESS JOBSITE AND UNEVEN GROUNDS
LOWERING QUICKLY THE MAST YOU CAN CLIMB ALMOST ANY SLOPE
SAFE TRANSPORTATION WITH A LOW CENTRE OF GRAVITY
QUICK AND EASY SET UP
TWO CROWD CYLINDERS PROVIDE MAXIMUM CROWD FORCE
meet your drilling needs
removable jib
compact mast
long boom
additional counterweight
crowd system
side tiltcylinders
fore/aft tilt cylinder
rigid guide
rotary drive
squareconnection
meet your drilling needs
Drilling on slopes andwith high side tilt
under severe overhead
Difficult access drilling
Long boom to drill over obstacles
Very low centre of gravity
Narrow spaces
meet your drilling needs
meet your drilling needs
DTC
30
DTC
50
DTC
80
torque 27 kNm
drilling depth 12.5 - 15 m
max pile diameter 800 mm
main winch line pull 35 kN
operating weight 8.8 tons
torque 47 kNm
drilling depth 19.5 - 29 m
max pile diameter 1200 mm
main winch line pull 80 kN
operating weight 14.5-16.5 tons
torque 82 kNm
drilling depth 31 m
max pile diameter 1500 mm
main winch line pull 120 kN
operating weight 24 tons
meet your drilling needs
TRANSPORT POSITION
DTC series is not just an excavatordrill attachment, it’s a rig fully integratedin the hydraulic and electric system.
Kelly guided in-mast guaranteesan excellent verticality in any condition
Its compact mast keeps theCG very low allowing higher manouvrability on sites
Based on reliable excavator basis built under Geax specifications permits lower fuel consumption and improved durability
meet your drilling needs
Simplified maintenance
Superb operator visibility
Diaphragm wall grab version
Drilling close to the wall
Customer care
Drilling on slopes
Geax is an italian company which designs and manufactures drilling and foundation machinery and equipment. Geax ‘s organisation is streamlined and efficient, enabling it to offer machines at a competiti-ve price and also to respond quickly to market needs. It was started up in 2006 by dr. Adriano Pesaresi, an engineer who already had twenty years’ experience as a designer in the sector. The new busi-ness initiative envisaged the production of drilling rigs which are inno-vative in structural terms, to make them compact, reliable, easy to use and highly efficient. A company working in the perforating sector for the building industry was set up in 2003 aimed at pinpointing the ne-eds of the industry and finding new solutions. Several years’ expe-rience in design combined with recent practical experience in worksi-tes have led to the production of models that have immediately won a large share of the market. All our machines start from the idea of increasing operational efficiency through dynamic design that is constantly measured against direct experience from continuous on-site tests. The DTC series, by adopting leading-edge solutions, represents a great step forward in a sector which has often been static and very conservative. On many sites our machines show outstanding versatility, quality, hourly productivity and ease of use compared with conventional drilling equipment. Innovation through acquired experience is fundamental to our working philosophy and all our products share this inspiration.
CEO ing. Adriano Pesaresi
www.geax.it
GEAX drilling equipmentvia Campoceraso n.13 Osimo (AN) ITALYtel. 0039 071 7131953fax.0039 071 715199write us at: [email protected]: www.geax.it