Acrylic Post-It StandTutorial (Part 2)
by Anne Marie Petersonhttp://didsomeonesaystamp.blogspot.com
8. For the beaded pen, start with an RSVP pen. Unscrew and remove theink barrel.
9. Cut a piece of 3-1/4 x 1” DSP to match the Post-It stand. Roll itvery tightly, almost folding it.
10. Insert the tightly rolled DSP into the barrel of the pen. Screw theink barrel/end back into the pen. (You might have to use tweezers topush the DSP into the barrel)
11. Using 1/8” wide sticky strip, wrap the strip diagonally around the pen.Press to make sure it's adhering very well.
12. Remove the red covering, and the pen cap, and roll the pen inmicrobeads. Use your fingers to press the beads into the adhesive.Roll again and press.
13. Replace the cap and you're done!
14. Finished product!
