+12v Constant = Yellow/black +12v Acc. Switch = Yellow -12v Chassis Ground= Black +12v Illumination = Red +12v Dimmer =Antenna/Amp Remote =Pink Can-Bus =
LF+ = GreenLF- = Orange
RF+ = Green RF- = Orange LR+ = Black LR- = Yellow RR+ = Brown RR- = White
Dash Type : Double DinAftermarket: Single/Double dinKit: KA2072B/KA2069BHarness: HY07BAntenna: Std. Motorola
About the Vehicle
Make: KiaModel: SedonaYear: 2006-09
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Rear
Kia Sedona2006-09
NOTES
Dimensions: Lower Door
Dimensions: W= L= D=
NOTES
Rear Side Panels: 6x9'' MidbassSpeaker Adapter: SA69Speaker Harness: TBAFactory Assembly: (4) T-20 Torx screws securingspeaker.
Standard/OptionalCD PlayerMP3 CompatibleRear DVD EntertainmentInfiniti Sound System
Ampli�er Locations: Under driver’s seat. W= 5.5'' L= 5.5'' D= 3.5''
Type: Standard Audio System Location: At Speakers
Speaker Sizes
INFINITI sounds system: 6 1/2" speaker in rear panel replacing the 6x9" 8" sub in left rear quarter panel.
A Pillar: 1'' TweeterLower Door: 6 1/2” MidrangeSpeaker Adapter: SAU56Speaker Harness: TBAFactory Assembly: (4) Phillips head Screws securingspeaker to adapter.
Kia Sedona
Images
Front Speakers
Radio removal
Front Speakers
Rear Speakers
1. Using a PRT extract the bezel surrounding the shifter.2. Using a PRT unsnap the dash bezel surroundingthe radio.3. Extract (1) PHS securing each air vent panel.4. Using a PRT unsnap and remove air vent panels.5. Extract (4) PHS securing factory A/C control panel.6.Extract (4) PHS securing radio to dash.
Radio
Recommended: Disconnect negative battery cable
A Pillar1. Remove (1) PHS behind SRS air bag badge on the "A" Pillar.2. Using a PRT unsnap "A" pillar and pull up and out to remove.3. Extract (2) screws to remove tweeter.
Rear Side Panels1.Remove trunk rear runner panel, and extract (1) PHS from each end.2. Extract (2) 14mm seat belt bolts3. Extract (2)10mm hex bolts located in floor jack compartment.4. Using a PRT unsnap the entire rear panel.5 Extract (4) T20 torx securing the factory speaker.
Rear Speakers
Front Door1. Extract (3) PHS along the perimeter of the doorpanel.2. Extract (1) PHS located inside the door handle.3. Extract (1) PHS located in the door handle release cup.4. Using a PRT unsnap the perimeter of the doorpanel.5. Lift away disconnect and remove.6. Extract (4) PHS securing factory speaker tospeaker adapter.
2006-09
