1
Section 11.1The Flow of Energy - Heat
OBJECTIVES:
• Explain the relationship between energy and heat.
2
Section 11.1The Flow of Energy - Heat
OBJECTIVES:
• Distinguish between heat capacity and specific heat.
3
Energy and Heat Thermochemistry - concerned with
heat changes that occur during chemical reactions
Energy - capacity for doing work or supplying heat
• weightless, odorless, tasteless
• if within the chemical substances- called chemical potential energy
4
Energy and Heat Gasoline contains a significant
amount of chemical potential energy Heat - represented by “q”, is energy
that transfers from one object to another, because of a temperature difference between them.
• only changes can be detected!
• flows from warmer cooler object
Exothermic and Endothermic Processes
Essentially all chemical reactions, and changes in physical state, involve either:
• release of heat, or
• absorption of heat
Exothermic and Endothermic Processes
In studying heat changes, think of defining these two parts:
• the system - the part of the universe on which you focus your attention
• the surroundings - includes everything else in the universe
Exothermic and Endothermic Processes
Together, the system and it’s surroundings constitute the universe
Thermochemistry is concerned with the flow of heat from the system to it’s surroundings, and vice-versa.
• Figure 11.3, page 294
Exothermic and Endothermic Processes
The Law of Conservation of Energy states that in any chemical or physical process, energy is neither created nor destroyed.
• All the energy is accounted for as work, stored energy, or heat.
Exothermic and Endothermic Processes
Fig. 11.3a, p.294 - heat flowing into a system from it’s surroundings:
• defined as positive
• q has a positive value
• called endothermic
–system gains heat as the surroundings cool down
Exothermic and Endothermic Processes
Fig. 11.3b, p.294 - heat flowing out of a system into it’s surroundings:
• defined as negative
• q has a negative value
• called exothermic
–system loses heat as the surroundings heat up
Exothermic and Endothermic Fig. 11.4, page 295 - on the left, the
system (the people) gain heat from it’s surroundings (the fire)
• this is endothermic On the right, the system (the body)
cools as perspiration evaporates, and heat flows to the surroundings
• this is exothermic
12
Exothemic and Endothermic
Every reaction has an energy change associated with it
Exothermic reactions release energy, usually in the form of heat.
Endothermic reactions absorb energy
Energy is stored in bonds between atoms
13
Heat Capacity and Specific Heat
A calorie is defined as the quantity of heat needed to raise the temperature of 1 g of pure water 1 oC.
• Used except when referring to food
• a Calorie, written with a capital C, always refers to the energy in food
• 1 Calorie = 1 kilocalorie = 1000 cal.
14
Heat Capacity and Specific Heat
The calorie is also related to the joule, the SI unit of heat and energy
• named after James Prescott Joule
• 4.184 J = 1 cal Heat Capacity - the amount of heat
needed to increase the temperature of an object exactly 1 oC
15
Heat Capacity and Specific Heat Specific Heat Capacity - the
amount of heat it takes to raise the temperature of 1 gram of the substance by 1 oC (abbreviated “C”)
• often called simply “Specific Heat”
• Note Table 11.2, page 296 Water has a HUGE value,
compared to other chemicals
16
Heat Capacity and Specific Heat
For water, C = 4.18 J/(g oC), and also C = 1.00 cal/(g oC)
Thus, for water:
• it takes a long time to heat up, and
• it takes a long time to cool off! Water is used as a coolant!
• Note Figure 11.7, page 297
17
Heat Capacity and Specific Heat
To calculate, use the formula: q = mass (g) x T x C heat abbreviated as “q” T = change in temperature C = Specific Heat Units are either J/(g oC) or cal/(g oC) Sample problem 11-1, page 299
18
Section 11.2Measuring and Expressing Heat
Changes
OBJECTIVES:
• Construct equations that show the heat changes for chemical and physical processes.
19
Section 11.2Measuring and Expressing Heat
Changes
OBJECTIVES:
• Calculate heat changes in chemical and physical processes.
Calorimetry Calorimetry - the accurate and
precise measurement of heat change for chemical and physical processes.
The device used to measure the absorption or release of heat in chemical or physical processes is called a Calorimeter
Calorimetry Foam cups are excellent heat
insulators, and are commonly used as simple calorimeters
• Fig. 11.8, page 300 For systems at constant pressure,
the heat content is the same as a property called Enthalpy (H) of the system
Calorimetry Changes in enthalpy = H q = H These terms will be used
interchangeably in this textbook Thus, q = H = m x C x T H is negative for an exothermic
reaction H is positive for an endothermic
reaction (Note Table 11.3, p.301)
Calorimetry Calorimetry experiments can be
performed at a constant volume using a device called a “bomb calorimeter” - a closed system
Figure 11.9, page 301 Sample 11-2, page 302
24
C + O2 CO2E
nerg
y
Reactants Products
C + O2
C O2
395kJ
+ 395 kJ
25
In terms of bonds
COO C
O
O
Breaking this bond will require energy.
CO
OOO C
Making these bonds gives you energy.In this case making the bonds gives you more energy than breaking them.
26
Exothermic The products are lower in energy
than the reactants Releases energy
27
CaCO3 CaO + CO2E
nerg
y
Reactants Products
CaCO3
CaO + CO2
176 kJ
CaCO3 + 176 kJ CaO + CO2
28
Endothermic The products are higher in energy
than the reactants Absorbs energy Note Figure 11.11, page 303
29
Chemistry Happens in
MOLES An equation that includes energy is
called a thermochemical equation CH4 + 2O2 CO2 + 2H2O + 802.2 kJ
1 mole of CH4 releases 802.2 kJ of energy.
When you make 802.2 kJ you also make 2 moles of water
30
Thermochemical Equations A heat of reaction is the heat
change for the equation, exactly as written• The physical state of reactants
and products must also be given.
• Standard conditions for the reaction is 101.3 kPa (1 atm.) and 25 oC
31
CH4 + 2 O2 CO2 + 2 H2O + 802.2 kJ
If 10. 3 grams of CH4 are burned completely, how much heat will be produced?
10. 3 g CH4
16.05 g CH4
1 mol CH4
1 mol CH4
802.2 kJ
= 514 kJ
32
CH4 + 2 O2 CO2 + 2 H2O + 802.2 kJ
How many liters of O2 at STP would be required to produce 23 kJ of heat? (1.28L)
How many grams of water would be produced with 506 kJ of heat? (22.7g)
Summary, so far...
34
Enthalpy The heat content a substance has at a
given temperature and pressure Can’t be measured directly because
there is no set starting point The reactants start with a heat content The products end up with a heat content So we can measure how much enthalpy
changes
35
Enthalpy Symbol is H Change in enthalpy is H (delta H) If heat is released, the heat content of
the products is lower
H is negative (exothermic) If heat is absorbed, the heat content
of the products is higher
H is positive (endothermic)
36
Ene
rgy
Reactants Products
Change is down
H is <0
37
Ene
rgy
Reactants Products
Change is upH is > 0
38
Heat of Reaction The heat that is released or absorbed in a
chemical reaction Equivalent to H C + O2(g) CO2(g) + 393.5 kJ
C + O2(g) CO2(g) H = -393.5 kJ
In thermochemical equation, it is important to indicate the physical state
H2(g) + 1/2O2 (g) H2O(g) H = -241.8 kJ
H2(g) + 1/2O2 (g) H2O(l) H = -285.8 kJ
39
Heat of Combustion The heat from the reaction that
completely burns 1 mole of a substance
Note Table 11.4, page 305
40
Section 11.3Heat in Changes of State
OBJECTIVES:
• Classify, by type, the heat changes that occur during melting, freezing, boiling, and condensing.
41
Section 11.3Heat in Changes of State
OBJECTIVES:
• Calculate heat changes that occur during melting, freezing, boiling, and condensing.
42
Heats of Fusion and Solidification
Heat of Fusion (Hfus) - the heat absorbed by a gram of a substance in melting from a solid to a liquid
Heat of Solidification (Hsolid) - heat lost when one gram of liquid solidifies
43
Heats of Fusion and Solidification
Heat absorbed by a melting solid is equal to heat lost when a liquid solidifies
• Thus, Hfus = -Hsolid
44
Heats of Vaporization and Condensation
When liquids absorb heat at their boiling points, they become vapors.
Heat of Vaporization (Hvap) - the amount of heat necessary to vaporize one gram of a given liquid.
45
Heats of Vaporization and Condensation
Condensation is the opposite of vaporization.
Heat of Condensation (Hcond) - amount of heat released when one gram of vapor condenses
Hvap = - Hcond
46
Heats of Vaporization and Condensation
Note Figure 11.5, page 310 The large values for Hvap and Hcond
are the reason hot vapors such as steam is very dangerous• You can receive a scalding burn
from steam when the heat of condensation is released!
47
Heats of Vaporization and Condensation
H20(g) H20(l) Hcond = - 2,260J/g How much heat is released by 34.0
grams of water vapor when it condenses to liquid water?
• (34.0g)(-2,260J/g) = -76,800J
48
Heat of Solution Heat changes can also occur when
a solute dissolves in a solvent. Molar Heat of Solution (Hsoln) -
heat change caused by dissolving of one mole of substance
Sodium hydroxide provides a good example of an exothermic molar heat of solution:
49
Heat of Solution
NaOH(s) Na1+(aq) + OH1-
(aq)
Hsoln = - 44.5 kJ/mol The heat is released as the ions
separate and interact with water, releasing 44.5 kJ of heat as Hsoln thus becoming so hot it steams!
H2O(l)