digital installation - 1 modern communication & broadcast system (mcbs) - 60cms prepared by...
TRANSCRIPT
Digital Installation - 1 Modern Communication & Broadcast System (MCBS) - 60cms Prepared By
Checked By Approved By Circulated By
Mr. Ashok Dubey
Mr. Sanjib Munshi Mr. Mukul Baweja Ms. Jyoti Shembi
Bulletin No: AS/07/10/DAKC/0021
Digital Installation - 1
Modern Communication & Broadcast System (MCBS) - 60cms
By the End of this session you will be able to: Identify the components of dish Antenna. Explain functions of each components. Assemble the components of dish Antenna. Install the complete dish antenna.
Objective
Component Identification
Components
Reflector Antenna Bracket Elevation Bracket LNBF arm with cap LNBF Clamp Mast Struts-2 Foot mount Nuts, Bolts & Screws
Reflector intercepts the incoming signal from the satellite and reflects to a common point called focal point.
Reflector
Reflector’s Rear view RimReflector’s Front view
Function of Reflector
LNBF
Reflector
It helps in fixing Reflector to LNBF Arm and Elevation Bracket. It is fixed on the rear side of Reflector.
Antenna Bracket
Direction to hold the Bracket Up ward Direction
Side view of the Antenna Bracket
Antenna Bracket
Elevation bracket is for elevation & azimuth angle setting and to fix Antenna bracket & Mast .
Elevation Bracket
Bolt fixed here acts as Stopper
Side View
Mast, Mount Clamp, Struts & Foot Mount
Mast
Struts
Foot Mount
LNBF Arm & LNBF Clamp
LNBF Clamp
LNBF Arm
LNBF Cap
Screws ,Bolts & Nuts
Screws, nuts and bolts are used to fix two or more parts.
Antenna Bracket & Elevation Bracket Bolts & nuts with Marker washers
LNBF Arm & Antenna Bracket , LNBF Arm & LNBF Clamp Nuts & Bolts
Antenna Bracket and reflector Nuts & posipan screws
LNBF Clamp Screws & Nuts
Foot Mount, Mast and Struts Nuts & Bolts
Dish Assembling Process
Fix the LNBF Arm to Antenna Bracket as shown. Check the arrow marking on the antenna bracket
Installation of Dish Antenna
Arrow mark
Complete assembly will be as below. The bolts to be inserted from the top of LNBF Arm & the nuts to be fixed at the back side of the Antenna Bracket as shown in the picture
Installation of Dish Antenna
Bolt from top
Installation of Dish Antenna
Fix the Antenna Bracket & Elevation bracket as below. The Elevation Bracket will be placed inside the Antenna bracket & accordingly the bolts & nuts will be fixed as shown in the pictures.
Installation of Dish Antenna
Complete Antenna Bracket, LNBF Arm & Elevation Bracket assembly.
Installation of Dish Antenna
Fix the complete bracket assembly to the Reflector.
Note: Always fix the Posipan screws & nuts diagonally
Installation of Dish Antenna
Fix the LNBF Clamp to the LNBF Arm.
Universal Mount Assembling Process
MAST SHOULD BE ALWAYS IN 90 DEGREES wrt GROUND (HORIZONTAL)
Installation of Dish Antenna
Fix the Mast to the Foot mount along with two Struts.
Installation of Dish Antenna
The complete assembly is as below. This is floor mount option. Always prefer Wall mount for installations.
Fix the LNBF to the LNBF Clamp
Stoppers Side ViewStoppers Front View
End of module