Crest Healthcare PJ Data Sheet, May 24, 2021, Rev. 1

(Typical only – some details may vary.)

SIZE (W X H X L) Overall dimensions of a fully equipped 17-gallon Cleaner: • 36 x 39 x 38.5" (914 x 889 x 871 mm)

Service Access Clearance:

• Minimum 24" (610 mm) all sides

FEATURES The PJ Series Ultrasonic Cleaning System is wired for operation on either 208 V (50/60 Hz, three phase [5 wire]/ single phase [4 wire]) or 240 V (50/60 Hz, single phase [3 wire]) voltage and shipped with power cord. Crest supplies a complete working unit ready for installation and connection to facility service lines. The Wash/Rinse Model includes the following features: (continued)

The Selections Checked Below Apply To This Equipment

VOLTAGES

Crest Healthcare Pro Junior Series Ultrasonic Cleaning System

APPLICATION Crest Healthcare Pro Junior (PJ) Series Ultrasonic Cleaning System is designed to thoroughly clean (remove tissue, blood and other contaminants) instruments prior to final disinfection and sterilization. The System’s compact design makes it suitable for use in the Central Supply or other instrument preprocessing areas to ultrasonically wash instruments prior to a disinfection and sterilization cycle.

DESCRIPTION

Crest Healthcare PJ Series Ultrasonics Cleaning System is a freestanding instrument cleaner with multiple wash/rinse cycle options supplied in a compact stainless-steel cabinet.

The ultrasonic washer contains all needed components to effectively wash (utilizing ultrasonic cavitation in a detergent-balanced wash solution) surgical instruments prior to disinfection and sterilization.

The PJ is equipped with an automatic opening lid and load elevator for ergonomic, easy and safe instrument loading, and touchscreen control.

STANDARDS

Crest Healthcare PJ Ultrasonic Cleaning System meets the applicable requirements of the following standards:

• Underwriters Laboratories (UL) Standard61010-1: 2nd Edition 2005 Electrical Safety.

• IEC-61010-1: 2001 Electrical Safety.• Canadian Standards Association (CSA)

Standard C22.2 No. 61010-1: 2nd Edition2004 Electrical Safety.

• Meets the CalOSHPD California Seismic"R" Standard.

• IEC 61010-1 Safety Requirements.

ACCESSORIES ❑ Seismic Restrainer Tie-Down Kit – set of 4

(3011520)❑ Replacement Instrument Tray (up to 24"):

❑ 17-gal (76 L) Tray (3017060❑ Endoscopic 10 Port Auxiliary Flushing Kit

with Brackets (2195300)❑ da Vinci XI Tray (3017PROS) - up to 26”❑ da Vinci SI Tray (3017PRO) - up to 24”

TANK SIZE ❑ 17-gal (64L)❑ 208 V, 50/60 Hz, 3ph (5 Wires Including

Protective Earth and Neutral)❑ 208 V, 50/60 Hz, 1ph (4 Wires Including

Protective Earth and Neutral)❑ 240 V, 50/60 Hz, 1ph (3 Wires Including

Protective Earth)

Crest Healthcare PJ Data Sheet, May 24, 2021, Rev. 1

NOTES Optimum Ultrasonic Cleaning Power is ensured by patented simultaneous multi-frequency design. Ultrasonic digital generators deliver dual (58/132 kHz) frequencies creating optimal cleaning action and noise reduction. The digital generators are mounted with individual slide out modules for ease of service. Also, patented ceramic transducer modules are bonded to the process tank providing efficient energy transmission for instrument cleaning.

Touch Screen Control enables operator to open lid, select cycle, start or pause cycle and monitor cycle progress from the touch screen controller.

Locking Caster Wheels are supplied for ease of PJ Ultrasonic Cleaning System movement.

Safety Interlocks and Controls help to ensure operator safety.

Large Capacity Process Tank Each new unit ships with one standard instrument tray. Tank is constructed of type 316 stainless steel with a BA finish.

• 17-gallon (64L) tank holds 35 lb (16 kg) of instruments

Illuminated Controls include MAIN POWER ON/OFF, ALERT: READ SCREEN and Touch Screen Display.

Two Chemical Probes are provided for Chem-Crest® containers of detergent and lubricant.

Front and Side Service Access Panels are supplied on the unit for ease of any maintenance procedures. Access doors are scratch and dent resistant. Lift-Out access panels are constructed of type 304 stainless steel. Front doors have automatic power cut-off feature to protect components and operator when doors are opened.

Base Plate, Frame and Removable Countertop are constructed of type 304 stainless steel.

Automatic Lid and E-Z Load Tray Elevator improve safety and increase instrument loading and unloading ease. E-Z Load Tray Elevator is positioned at a convenient working height and is oriented laterally for ease of loading and unloading heavy instrument trays.

Port Flushing System processes up to 10 rigid lumened surgical devices with both ultrasonic energy and internal flushing.

Warranties:• Transducer Bonding: 10 Years• Generator: 2 Years• Equipment: 1 Year

1. Pipe sizes shown indicate terminal outlets only. Buildingservice lines (not provided by Crest) must supply thespecified pressures and flow rates.Crest recommends that a dedicated, grounded electricalcircuit be provided for each unit. Do not use extension cordand plug.Approximate operating weight: 545 lb (247 kg).Pro Junior must be mounted on a hard, non- combustiblelevel surface.Crest requires as a minimum for floor sink: 6" diameter x 6"deep with a 2" minimum outlet pipe from the bottom.C r e s t requires minimum clear openings from loading dock toinstallation point of 44" (1118 mm) for Cleaners. Doorswith openings narrower than this 44" (1118 mm) requirementmay need door and/or frame removal.

2.

3. 4.

5.

6.

UTILITY REQUIREMENTS

Refer to manual for installation details and specifications.

Electrical 208 V, 50/60 Hz, 3-Phase (5 Wire); 208V, 50/60 Hz, 1-Phase (4 Wire); 240V, 50/60 Hz, 1-Phase (3 Wire)

Drain (Gravity) 1" FPT CPVC (trap and waste lines are not provided by Crest). Maximum flow: 10 gpm. Maximum water temperature: 120°F (49°C).

Drain (Pump) 3/4" FPT CPVC (trap and waste lines are not provided by Crest). Maximum flow: 20 gpm . Maximum water temperature: 120°F (49°C).

Hot Tap Water (SS) 1/2" FPT (38 psi Maximum); 110-120°F (43-49°C).

Cold Tap Water (SS) 1/2" FPT (38 psi Maximum); 40-60°F (4-16°C).

Deionized Water (SS) 1/2" FPT (38 psi Maximum); 65-120°F (18-49°C).

NOTE: Electrical and plumbing connection must be flexible or contain a disconnect to allow unit to be moved from the wall for servicing.

The base language of this document is ENGLISH. Any translations must be made from the base language document.

CUSTOMER IS RESPONSIBLE FOR COMPLIANCE WITH APPLICABLE LOCAL AND NATIONAL CODES AND REGULATIONS.

2

Crest Healthcare PJ Data Sheet, May 24, 2021, Rev. 1

Crest Healthcare Pro Junior Technical Data

*Maximum tray size†Amperage value shown is actual current drain. Disconnect should be at least 25% more.**4 Wires including Neutral and Protective Earth.‡5 Wires including Neutral and Protective Earth.+3 Wires including Protective Earth.

3

MODEL

CHP 17W

SKU #

POWER REQUIREMENTS (Amps)† SONIC

POWER (Watts)

SHIP WEIGHT lb (kg)

TANK FLUID

CAPACITY gal (L)

HEAT LOSS (BTU)

TRAY SIZE

L x W x D* in (mm)

208 V 240 V

1 PH** 3 PH‡ 1 PH+

CHP1172083 26 2000 794

(360) 17

(64) 300 24 x 14 x 3

(610 x 356 x 76)

CHP1172081 33 2000 794(360)

17 (64)

300 24 x 14 x 3 (610 x 356 x 76)

CHP1172401 30 2000 794(360)

17 (64)

300 24 x 14 x 3 (610 x 356 x 76)

RECOMMENDED DETERGENT AND LUBE OPTIONS

NOTE: Please contact your Crest Ultrasonics representative for detergent recommendations based upon your specific application.

Chem-Crest® 407-L is a non-hazardous petroleum distillate designed to be used at full strength in an ultrasonic bath for the primary use of displacing and absorbing rinse water and for the lubrication of medical components. This solution is designed to absorb large quantities of water, which can later be settled out for the purpose of reusing the lubricant.

Chem-Crest® 14EZ

Chem-Crest 14EZ is a mildly alkaline and enzymatic liquid detergent for the cleaning of surgical instruments. It is designed to be used in an ultrasonic bath for the removal of blood, tissue, ointments, light oils, bodily excretions, and other contaminants associated with surgical instruments. It is formulated to be low foaming and an aggressive blood remover. It is non-caustic and phosphate-free.

Chem-Crest® LF275

Chem-Crest LF275 is a multipurpose, heavy-duty, phosphate- and silicate-free caustic liquid detergent. It is useful in many applications demanding removal of various contaminants such as oils, greases, and particulates. This detergent finds many uses throughout medical, industrial, mechanical, and maintenance cleaning operations – including spray and turbulent environments.