Page 3 of 11

CREO 2.0 LIST OF PRACTICALS TO BE PERFORMED

practical1. Introduction and revision of modelling tools to be used in creo parametric

Practical 2. Modelling of different components of the cotter joint.

PRACTICAL 3. Assembly of different components of the COTTER joint.

PRACTICAL 4. Modelling of different components of the KNUCKLE JOINT

Practical 5 . Assembly of different components of the KNUCKLE JOINT

Practical 6. Modelling the different components of the screw jack.

Practical 7. Assembly of the different components of the screw jackPractical 8. Modelling the different components of the PLUMMER BLOCK

Practical 9. Assembly of the different components of the PLUMMER BLOCK.

Practical 10. Modelling the different components of the FLANGE COUPLING

Practical 11. Assembly of the different components of the FLANGE COUPLING.

Practical 12. Modelling the different components of the cam and follower.

Practical 13. Assembly of the different components of the cam and follower

Practical 14. Modelling the different components of the Oldham coupling

Practical 15. Assembly of the different components of the Oldham coupling

Practical 16. Modelling the different components of the slider crank mechanism

Practical 17. Assembly of the different components of the slider crank mechanism

Practical 18. Modelling the different components of the spur gear

Practical 19. Assembly of the different components of the gear train

Practical 20. Use of helical sweep command to construct springs

Practical 21. Use of revolve command to construct objects.

Practical 22. Modelling the different components of a fan

Practical 23. To create a bolt and nut assembly using creo

Practical 24. To make an impeller using creo

Practical 25. Simulation of cam follower arrangement.

Practical 26. Simulation of the slider crank mechanism

Practical 27. Simulation of the Oldham coupling mechanism

Practical 28. Simulation of the gear train.

Practical 29. Simulation of planetary gear train.

Practical 30. Mechanical analysis of beam in creo

Practical 31.Mechanical analysis of cam and follower movement

Practical 32. Direct modelling of chain drive and its sprockets

Practical 33. Simulation of chain drive and its sprockets

Practical 34. Modelling damper system of a mass spring damper system

Practical 35. Simulation of a mass spring damper system