correction to bexperimental design of a nonlinear
TRANSCRIPT
7/23/2019 Correction to BExperimental Design of a Nonlinear
http://slidepdf.com/reader/full/correction-to-bexperimental-design-of-a-nonlinear 1/1
The lower part of Fig. 4 of the above paper [1] con-
tained incorrect references to equations in the paper. In the
figure, the referenced equations BEq. (22),[ BEq. (23),[ and
BEq. (31)[ in the boxes should have been BEq. (13),[ BEq. (14),[
and BEq. (20),[ respectively, as shown in the figure given
below.
REFERENCES
[1] S. Rahmani, N. Mendalek, and K. Al-Haddad, BExperimental designof a nonlinear control technique for three-phase shunt active power filter,[ IEEE Trans. Ind. Electron., vol. 57, no. 10, pp. 3364–3375,
Oct. 2010.
Comments and Corrections
Fig. 4. Nonlinear control scheme of the SAPF.
Manuscript received September 21, 2010. Date of current versionNovember 10, 2010.
S. Rahmani and K. Al-Haddad are with the Ecole de Technologie,Superieure, University of Quebec, Montreal, QC H3C 1K3, Canada (e-mail:[email protected]; [email protected]).
N. Mendalek is with the Department of Electrical, Computer and Com-munication Engineering, Notre Dame University, Louaize, Lebanon (e-mail:[email protected]).
Digital Object Identifier 10.1109/TIE.2010.2081810
IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, VOL. 57, NO. 12, DECEMBER 2010 4231
0278-0046/$26.00 2010 IEEE
Correction to BExperimental Design of a Nonlinear
Control Technique for Three-Phase Shunt
Active Power Filter[
Salem Rahmani, Nassar Mendalek, and Kamal Al-Haddad