1

Connecting the A-49 to an iPadBefore you continue, please make sure to access the following URL and check the operating requirements and other relevant information.

http://www.roland.com/support/

NOTE

• The first-generation iPad cannot be used.

• The iPad app you’re using must support CoreMIDI.

You’ll need to provide the following items• iPad (made by the Apple Inc.)

• Apple iPad Camera Connection Kit (Camera Connector; made by the Apple Inc.)

• USB hub (commercially available; a type to which an AC adaptor or other power supply is connected)

• Two USB cables (included with the A-49 or commercially available)

Using the A-49 with an iPadWhen using the A-49 with an iPad, switch the USB driver used by the A-49 to “GENERIC.”

Use the following procedure to make this setting.

1

3

2

5

Apple iPad Camera Connection Kit (Camera Connector)

AC adaptor included with the USB hub

4

USB hub that works with a connected power supply (commercially available)

1. Power up your USB hub (connect the AC adaptor to the USB hub).

2. Connect the USB hub to the iPad using the Camera Connector of the Apple iPad Camera Connection Kit.

3. While holding down the [S1] button and [S2] button, connect the A-49 to the USB hub.Once the A-49’s power has turned on, release the [S1] button and [S2] button.

4. Press the [FUNCTION] button " [ADV] key (keyboard) " [-] button, in that order.

5. Disconnect the USB cable from the A-49, and then reconnect it.

MEMO

• It will not be necessary to switch the USB driver the next time you use the A-49 while connected to the iPad. Following steps 1–2, simply connect the A-49 to the USB hub and it will be ready for use.

• Operation may be unstable if you use a USB hub of a type that does not have a connected power supply, or if you connect the A-49 directly to the iPad.

A-49

Connecting the A-49 to an iPad

2

Using the A-49 with a ComputerIf you want to use the A-49 while it’s connected to a computer after having previously connected it to an iPad, you must switch the USB driver used by the A-49 to “ADVANCED.”

1 3

2

1. While holding down the [S1] button and [S2] button, connect the A-49 to the computer.Once the A-49’s power has turned on, release the [S1] button and [S2] button.

2. Press the [FUNCTION] button " [ADV] key (keyboard) " [+] button, in that order.

3. Disconnect the USB cable from the A-49, and then reconnect it.

MEMO

• If you’re connecting the A-49 to a computer in which the USB driver has not been installed, disconnect the USB cable from the A-49, and install the USB driver in the computer as described in the section “Installing the Driver” in the owner’s manual for the A-49.

• It will not be necessary to switch the USB driver the next time you connect the A-49 to the computer. Simply connect the A-49 to the computer and it will be ready for use.

Copyright © 2012 ROLAND CORPORATION

All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.

Company names and product names appearing in this document are registered trademarks or trademarks of their respective owners.