Compensator Eliminator #4513WWW.VULCANWORKS.NET603-668-6315

Manufactured byMotorway Engineering

85 Hancock St. Manchester, NH, 03101USA

Bend one of the tabs back and slide out all of the belleville springs

*Remove Primary Cover

*Remove Compensator Bolt

*Remove Clutch Hub, Chain and Compensator together.

This step is optional, but leaving the spring pack in may cause noise and/or an imbal-ance.

*Slide Alternator Rotor off shaft

Instructions for most 2006-10 Bikes with stock style compensator shown to the right.

WWW.VULCANWORKS.NET603-668-6315

• Important: Refer to the Ser-vice Manual for your bike for a complete installation proce-dure.

• The Motor sprocket, Chain and Clutch hub must be installed at the same time.

• Install Bolt with red Loctite and included washer(Recessed Side toward Motor).

• Torque To 140-165 FT-Lbs

Springs Removed

• Mount Alternator Rotor back on shaft

Instructions for most 2010-up Bikes with Screaming Eagle style compensator shown

to the right.

WWW.VULCANWORKS.NET603-668-6315

*Remove Primary Cover

*Remove Compensator Bolt

*Remove Clutch Hub, Chain and Compensator together.

• Important: Refer to the Service Manual for your bike for a complete installation procedure.

• Install included Large Washer onto motor sprocket shaft.

•• The Motor sprocket, Chain and

Clutch hub must be installed at the same time.

• Install Bolt with red Loctite and included washer(Recessed Side toward Motor).

• Torque To 145-165 FT-Lbs