•Depress power button to turn on and wait, it takes a few seconds •Make sure key guard is attached•Student needs wheelchair tray on

•Attach mount into the mount holder on the lower right side of the wheelchair •Attach the Dynavox to the mount by pulling out the pin and sliding the Dynavox in until

pin locks•Student needs to wear wrist splints and finger splint

•Place a pillow or the yoga block under student’s left elbow

Power Power Indicator

•Make sure freshly charger batteries are inserted•Press and release power button

•Student needs wheelchair tray on•Pull out built in easel on the back and place on wheelchair tray and use a large plastic

clamp to secure

Power Power Indicator

Built in easel

•Remove device from case•Press and release power button

•Student needs wheelchair tray on•Attach Chat PC to tray by sticking onto the Velcro near the joystick•Student may not have food or drink present with Chat PC on tray

Power Power Indicator

•Turn on •Set to correct level, make sure picture matches voice output by pressing a few of the

buttons•Adjust volume, if using headphone plug into speaker port

•Place in the a location that the student can easily reach, without accidently pressing•Make sure that the device is secure and will not slide or fall

Power

Level KnobSpeaker

Port

•Turn on •Set to correct level, make sure picture matches voice output by pressing a few of the

buttons•Place in the a location that the student can easily reach, without accidently pressing

•Make sure that the device is secure and will not slide or fall

Levels

Power

•Slide button to on•Turn up volume

•To record press record button and the switch top at the same time, say your message then release buttons•Adjust volume

•Place in the a location that the student can easily reach, without accidently pressing•Make sure that the switch is secure and will not slide or fall

Power

•Slide button to on•Turn up volume

•Follow directions on switch to record (we have two version with different directions)•Adjust volume

•Place in the a location that the student can easily reach, without accidently pressing•Make sure that the switch is secure and will not slide or fall

Power