cma bdhh 6519 e0-8 pa1 [kompatibilitetsläge] -...

1
GSM / CDMA: 1800, 1900 & 2100 CMA-BDHH/6519/E0-8 Electrical specification: Frequency range 1800: 1710-1880 MHz 1900: 1850-1990 MHz 2100: 1920-2170 MHz Polarization 2 x Dual linear 45º Gain 1800: 4 x 18.4 dBi 1900: 4 x 18.8 dBi 2100: 4 x 19.3 dBi Horizontal = 3 dB beamwidth 65º 3º Vertical = 3 dB beamwidth 1800: 7.4º 0.3º 1900: 6.7º 0.2º 2100: 6.2º 0.3º Adj tbl l ti l d tilt Adjustable electrical downtilt -VSWR <1.5:1 Isolation between inputs >30 dB Front to back ratio >25 dB First upper sidelobe suppression >18 dB First nullfill below horizon <20 dB Cross-polar discrimination >20 dB Inter modulation, IM3 (GSM) >153 dBc@2x43 dBm Inter modulation, IM7 (UMTS) >163 dBc@2x43 dBm Antenna Efficency* 95 % Nominal impedance 50 Max power per input 500 W Mechanical specification: Connectors 4 x 7/16 female Connector position Bottom Lightning protection DC grounded Height/Width/Depth mm (in) 1290 (51)/403 (15.8)/133 (5.2) Antenna weight 19 kg (44 lb) Wind load at 42 m/s (94 mph) : Frontal 688 N (154 lbf) Lateral: 172 N (38 lbf) Rear: 802 N (180 lbf) Survival wind speed 60 m/s (134 mph) Colour radome Light Grey, RAL 7035 Colour radome Light Grey, RAL 7035 Radome material ASA Mounting hardware: Mounting bracket 2 Bracket weight (complete) 5,6 kg (12 lb) Pole diameter 45-120 mm (1.8-4.7 in) Tilt bracket 0º-6º mechanical © 2009 CellMax Technologies AB reserves the right to modify or change the above specifications without notice. * Based on true measurements and calculated according to P rad /P in .

Upload: phamkien

Post on 29-May-2018

241 views

Category:

Documents


7 download

TRANSCRIPT

Page 1: CMA BDHH 6519 E0-8 PA1 [Kompatibilitetsläge] - DrawComdrawcom.com.au/wp-content/uploads/CMA-BDHH6519E0-8.pdf · CMA-BDHH/6519/E0-8 Electrical ... CellMax Technologies AB reserves

GSM / CDMA: 1800, 1900 & 2100

CMA-BDHH/6519/E0-8

Electrical specification:Frequency range 1800: 1710-1880 MHz

1900: 1850-1990 MHz2100: 1920-2170 MHz

Polarization 2 x Dual linear 45º

G i 1800 4 18 4 dBiGain 1800: 4 x 18.4 dBi1900: 4 x 18.8 dBi2100: 4 x 19.3 dBi

Horizontal = 3 dB beamwidth 65º 3º

Vertical = 3 dB beamwidth 1800: 7.4º 0.3º1900: 6.7º 0.2º2100: 6.2º 0.3º

Adj t bl l t i l d tilt 0º 8ºAdjustable electrical downtilt 0º -8º

VSWR <1.5:1

Isolation between inputs >30 dBFront to back ratio >25 dBFirst upper sidelobe suppression >18 dBFirst nullfill below horizon <20 dBCross-polar discrimination >20 dB

Inter modulation, IM3 (GSM) >153 dBc@2x43 dBmInter modulation, IM7 (UMTS) >163 dBc@2x43 dBmAntenna Efficency* 95 %Nominal impedance 50 ΩMax power per input 500 W

Mechanical specification:Connectors 4 x 7/16 femaleConnector position BottompLightning protection DC groundedHeight/Width/Depth mm (in) 1290 (51)/403 (15.8)/133 (5.2)Antenna weight 19 kg (44 lb)

Wind load at 42 m/s (94 mph) : Frontal 688 N (154 lbf)Lateral: 172 N (38 lbf)Rear: 802 N (180 lbf)

Survival wind speed 60 m/s (134 mph)Colour radome Light Grey, RAL 7035 Colour radome Light Grey, RAL 7035 Radome material ASA

Mounting hardware:Mounting bracket 2Bracket weight (complete) 5,6 kg (12 lb)Pole diameter 45-120 mm (1.8-4.7 in)Tilt bracket 0º-6º mechanical

© 2009 CellMax Technologies AB reserves the right to modify or change the above specifications without notice.

* Based on true measurements and calculated according to Prad/Pin.

office
Typewritten Text
Drawcom Pty Ltd Level 1, 70 - 80 Wellington Street, Collingwood VIC 3066, AUSTRALIA Phone: +61 3 9604 6900 Fax +61 3 604 6999 www.drawcom.com.au, [email protected]