cl-41 & pg-40 cartridge refill instructions
DESCRIPTION
Refill Instructions for Canon PIXMA 1xx cartridgesTRANSCRIPT
Canon Cartridge PG-41 (#41)
Refill Instructions for Color cartridge Instructions
1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Peal off the top label.
3. You will notice three small holes (too small for a syringe needle to get into). Drill each hole larger with a thumb drill.
4. Fill the syringe with 6 ml. of color ink.
5. Very S-L-O-W-L-Y inject ink into each chamber until the sponge full
ished, replace the top label or leave it off (it will make no difference in the printing).
per printer instructions.
6. When fin
7. Replace the cartridge and run 1 - 3 cleaning cycles asOr print the following page: http://www.refillinstructions.com/color.htm For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge. (Allows ink to flow to the print head).
on the printer. Holding the paper feed button down for 3-5 sec. will allow you to override the counter.
ould include Ink plus the following:
Three 10cc Syringes with sharp needle
Note: Each time the cartridge is removed from the printer an "empty cartridge" message appears and a blinking amber light will come on,
A Refill Kit shThumb Drill
Canon Cartridge PG-40 (#40) and PG-50 (#50)
Refill Instructions for Black cartridge
Instructions
1. Put the cartridge on some paper towels in an area where you can tolerate a spill.
2. Drill a hole into the dimple just below the "B".
3. Fill the syringe with 20 ml. of black ink.
4. Very S-L-O-W-L-Y inject ink into the drilled hole.
ape over the drilled hole, but this is not necessary.
run 1 - 3 cleaning cycles as per printer instructions.
5. When finished, you can put a small piece of t
6. Replace the cartridge andOr print the following pages: http://www.refillinstructions.com/black.htm for Black For best results, leave cartridge in printer for 8 hours after refilling so the ink can saturate the entire sponge.
Note: Each time the cartridge is removed from the printer an "empty cartridge" message appears and a blinking amber light will come on, on the printer. Holding the paper feed button down for 3-5 sec. will allow you to override the counter.