Checklists for Sketching

• Create a 3 View Multiview Sketch

• Checklist for Multiview Drawings

• Checklist for Isometric Drawings

• Checklist for Oblique Drawings

• Checklist for Drawing Sections

• Checklist for Auxiliary Drawings

• Dimensioning Rules

Create a 3 View Multiview Sketch

• Choose Front, Side & Top View

• Layout blocks for each view.

• Sketch front view.

• Project height to side view and width to top.

• Use construction lines to transfer features.

• Adjust line weights and add center & hidden lines.

See text page 122 to 123

Checklist for Multiview Drawings

• Equal spacing between views

• Center line is shown in all views.

• Views are aligned.

• Views have standard arrangement.

• Line weights are correct.

• Line types are correct

See text page 119 to 123 and 382-437

Checklist for Isometric Drawings

• Draw box with Isometric axis 30o from horizontal.

• Draw all lines true length

• No hidden lines

• Use 4 center Ellipse method for circles

• To draw non-isometric lines plot end points then connect.

See text page 101 to 107 and 468-485

Checklist for Oblique Drawings• Place circular features on front view

• Choose receding angle and direction to show the best view of the object

• No hidden lines

• Use 4 Center Ellipse method for circles

• Check to see if back of hole shows

• Cavalier oblique depth is true length

• Cabinet oblique depth is half size

See text page 108 to 109 and 498-507See text page 108 to 109 and 498-507

Checklist for Drawing Sections

• Draw at least two multiviews.• Place the section view in relation to

multiviews.• Use the multivews to transfer info to section• Label the section:

1. Show cutting plane with letters (i.e. A, A or B,B)2. Title the section view ( i.e. Section AA)3. Show arrows on cutting plane corresponding to

position of section

See text page 642 to 668