1

CCNA 4 Frame Relay(II)

2 2 2

Purpose of This PowerPoint

• This PowerPoint primarily consists of the Target Indicators (TIs) of this module in CCNA version 3.0.

• It was created to give instructors a PowerPoint to take and modify as their own.

• This PowerPoint is:

NOT a study guide for the module final assessment.

NOT a study guide for the CCNA certification exam.

• Please report any mistakes you find in this PowerPoint by using the Academy Connection Help link.

3 3 3

To Locate Instructional Resource Materials on Academy Connection:

• Go to the Community FTP Center to locate materials created by the instructor community

• Go to the Tools section

• Go to the Alpha Preview section

• Go to the Community link under Resources

• See the resources available on the Class home page for classes you are offering

• Search http://www.cisco.com

• Contact your parent academy!

4 4 4

Objectives

• Frame Relay concepts

• Configuring Frame Relay

5 5 5

Frame Relay Operation

6 6 6

Frame Relay Switches

7 7 7

Frame Relay Concepts

8 8 8

Local Significance of DLCIs

The data-link connection identifier (DLCI) is stored

in the Address field of every frame transmitted.

9 9 9

Terminology

• The connection through the Frame Relay network between two DTEs is called a virtual circuit (VC).

• Virtual circuits may be established dynamically by sending signaling messages to the network. In this case they are called switched virtual circuits (SVCs).

10 10 10

Frame Relay Stack Layered Support

11 11 11

Frame Relay Functions

12 12 12

Bandwidth and Flow Control

Bit counter Example 1

13 13 13

Frame Relay Concepts

14 14 14

LAPF Frame

15 15 15

Full-Mesh Topology

16 16 16

Frame Relay Mesh

17 17 17

LMI

• Three types of LMIs are supported by Cisco routers:

Cisco — The original LMI extensions

Ansi — Corresponding to the ANSI standard T1.617 Annex D

q933a — Corresponding to the ITU standard Q933 Annex A

18 18 18

Stages of Inverse ARP and LMI Operation #1

19 19 19

Stages of Inverse ARP and LMI Operation #2

20 20 20

Configuring Basic Frame Relay

21 21 21

Configuring a Static Frame Relay Map

22 22 22

Reachability Issues with Routing Updates in NBMA

By default, a Frame Relay network provides nonbroadcast

multiaccess (NBMA) connectivity between remote sites.

An NBMA environment is treated like other multiaccess

media environments, where all the routers are on the

same subnet.

23 23 23

Frame Relay Subinterfaces

24 24 24

Configuring Point-to-Point Subinterfaces

25 25 25

Verifying Frame Relay

• The show interfaces command displays information regarding the encapsulation and Layer 1 and Layer 2 status. It also displays information about the following:

The LMI type

The LMI DLCI

The Frame Relay data terminal equipment/data circuit-terminating equipment (DTE/DCE) type

26 26 26

The show frame-relay lmi Command

27 27 27

The show frame-relay pvc Command

28 28 28

The show frame-relay map Command

29 29 29

Troubleshooting Frame Relay

• Use the debug frame-relay lmi

command to determine whether the router and the Frame Relay switch are sending and receiving LMI packets properly.