camtasia - using relay - edith cowan university · camtasia - using relay 1. open camtasia...
TRANSCRIPT
Centre for Learning and Teaching
Edith Cowan University
Centre for Learning and Teaching Tel: +61 8 6304 2554 | Email: [email protected] | Web: intranet.ecu.edu.au/learning
CRISCOS IPC 00279B
Camtasia - Using Relay
1. Open Camtasia (TechSmith) Relay. Select the Presenter button. Enter your ECU Username
and Password and click the Log in button.
2. Click on the Audio icon and select the microphone you will be using. Test the microphone by
clicking the blue test button and recording a short test. You should see green bars moving in
the Audio Input Level area if the microphone has been set up correctly.
Press the stop button when you are finished your test. Relay will replay your recording.
Centre for Learning and Teaching
Edith Cowan University
Centre for Learning and Teaching Tel: +61 8 6304 2554 | Email: [email protected] | Web: intranet.ecu.edu.au/learning
CRISCOS IPC 00279B
3. When you are ready to begin recording your presentation, click the red record button.
4. When you are finished, click the Stop button. It will take up to a minute to finalise.
5. [Optional] Use the trimming button to trim the beginning and/or end of the recording.
6. Enter a Title for your recording and click the Submit button.
7. For best results, leave your computer open, active and connected to the network for at least 10
minutes to allow the recording to upload to the server.